Front Trailer Hitch Receiver For 2024 GMC Sierra 1500 With Duramax Diesel and Max Trailering Package

Question

Question:

Will the Draw Tite front hitch DT44HR Fit a 2024 GMC Sierrawith the 3.0 diesel and max trailering package?

asked by: Michael B

0

Expert Reply:

Yes, the Draw-Tite Front Mount Trailer Hitch Receiver # DT44HR will fit your 2024 GMC Sierra 1500 with the 3.0L Duramax diesel with the max trailering package.

expert reply by: Bud M

0

Answer 1

Hello Paul, I checked with Draw-Tite and yes, the Draw-Tite Front Mount Trailer Hitch Receiver #DT44HR is a fit for your 2024 Chevy Silverado 1500 LTZ.

view full answer...

Answer 2

Draw-Tite's fitment guide has no stipulations on sub models for the 2023 GMC Sierra 1500 so you would be able to install the Draw-Tite Front Mount Trailer Hitch Receiver #DT44HR. You will have to trim the fascia and if you have an AEV or Warn…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 5

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Answer 10

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Front Trailer Hitch Receiver For 2024 GMC Sierra 1500 With Duramax Diesel and Max Trailering Package

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching