Brake Line Fitting Size Needed For The Dexter DX7.5L A-60 Brake Actuator w Electric Lockout # DX56FR

Question

Question:

Hello! What is the orifice size of the female break line fitting on the back of the break lock out selonoid? Many thanks!

asked by: David H

0

Expert Reply:

Hey David,

The Dexter DX7.5L A-60 Brake Actuator w Electric Lockout # DX56FR accepts brake lines with 3/16" male inverted flare fittings with a 3/8"-24 thread size like the DeeMaxx Hydraulic Brake Line # DE38GR.

expert reply by: Kevin C

0

David H.

4/9/2024

Thank you so much!

Reply

Answer 1

We can help you with either new disc brakes or with replacement parts for your existing disc brake setup on your Ranger boat trailer. Either way you will want to confirm the axle rating of the single or tandem axles on the trailer since complete…

view full answer...

Answer 2

It sounds like you are using a slip on rotor for your disc brake conversion. This will cause the wheels on the braking axle to sit slightly farther out than the wheels on the non-braking axle. This is due to the thickness of the rotor, which is is…

view full answer...

Answer 3

The correct replacement actuator for your UFP 34034 is the Dexter DX7.5L A-60 part #DX56FR.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

Hey Joe, The track mount kit referred to in the item description of the Rhino-Rack Reconn-Deck Truck Bed Rack Towers #RR62FH is referring to OEM utility rails in the bed of the truck, not a separate Rhino-Rack branded kit. To fit different vehicle…

view full answer...

Answer 7

The MaxxFan Deluxe Roof Vent w/ 12V Fan and Thermostat item #MA00-06200K uses up to 5-Amps to operate when running and up to 9-Amps for startup. So probably between 90 - 100 hours if it was the only thing running and you left it on.

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

Your surge coupler will have either a sticker or an engraving on it, typically near where the coupler is located. If you can get me that information and what you're needing to replace on it I'd be more than happy to help you find what…

view full answer...

Answer 12

Yes, you can weld on the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Bolt On - Disc - 2" Ball - Zinc - 7.5K item #DX56FR you referenced. You will want to make sure you remove the zinc coating and get down to the bare metal. I have…

view full answer...