Weight of Torklift Talon Tie Downs and FastGun TurnBuckles

Question

Question:

Any chance you can give me the weights of front and rear talons # TL73QR #TL44XR and also a set of fast guns TLS9529-2LK Thanks

asked by: Bob R

0

Expert Reply:

Hey Bob, the Torklift Talon tie downs part # TL73QR weighs 35 lb.

The TorkLift Talon Camper Tie-Downs # TL44XR weigh 26 lb.

TorkLift Locking FastGun Turnbuckles # TLS9529-2-LK weighs 20 lb.

expert reply by: Jameson C

0

Answer 1

If you take a look at the linked diagram you can see the minimum recommended clearance distances between truck and trailer for 5th wheel towing. It is recommended to have at least 5-inches from the top of the bed rails to the bottom of the trailer…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Richard, thanks for reaching out! The Air Lift LoadLifter 7500 XL Air Helper Springs #AL57541 does take up the same space as the Curt 19419346 5th wheel bracket kit for your 2024 GMC Sierra 3500. The only way to remedy this is to use the…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

Hey Bob, the Torklift Talon tie downs part #TL73QR weighs 35 lb. The TorkLift Talon Camper Tie-Downs #TL44XR weigh 26 lb. TorkLift Locking FastGun Turnbuckles #TLS9529-2-LK weighs 20 lb.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 9

That's weird, the 7-Way Vehicle Power Adapter for Furrion RV Observation Camera #FR87PR should allow you to use your camper at the same time as that's what it's designed for. If you want to just avoid the adapter all together, I would…

view full answer...

Answer 10

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 11

Yes you can absolutely use the HappiJac Qwik-Load Turnbuckles for Camper Tie-Downs #LC182895 with your TorkLift tie downs.

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Weight of Torklift Talon Tie Downs and FastGun TurnBuckles

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching