What Is The Correct Reverse Lockout For A Dexter DX12.5 Actuator?

Question

Question:

I have a Dexter DX12.5 actuator. what is the correct reverse lockout ?

asked by: Donald D

0

Expert Reply:

For your Dexter DX12.5 actuator, you will need to use a reverse lockout solenoid. For that we recommend the Replacement Solenoid Valve for Dexter Brake Actuators # T4748800. I have linked our install video below if you want to take a look.

expert reply by: Jesse M

0

Answer 1

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

view full answer...

Answer 2

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

view full answer...

Answer 3

The Demco Hydraulic Brake Actuator part #DM72VR is a great option to replace an Atwood 82543. That said, it does not come with any sort of reverse lockout feature therefore in order to reverse without the brakes locking up you will either need to add…

view full answer...

Answer 4

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 5

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

view full answer...

Answer 6

The closest option we have to replace your Atwood 82543 actuator is part #DM72VR. However, it doesn't have the lockout like your Atwood does. To add a lockout use #T4748800 but it's an electric lockout unlike the Atwood's manual lockout.…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

I can certainly point you in the right direction. Switching from hydraulic drum brakes over to EOH disc brakes is basically going to require a full conversion kit. It may be possible to re-use some of the old brake lines, but if you are doing a full…

view full answer...

Answer 9

Thank you for including images, this was a great help to me understanding what you will need to do to equip your trailer with electric brakes. The best thing for you to do is to immobilize the surge coupler. To do this you can weld the inner part of…

view full answer...

Answer 10

Like you said, many factory integrated brake controllers will not work well with electric over hydraulic trailer braking systems. Some of the newer versions of these controllers now have an electric over hydraulic mode. Check to see if any of your…

view full answer...

What Is The Correct Reverse Lockout For A Dexter DX12.5 Actuator?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching