Will the 2-Tang Clevis for BulletProof Hitches Adjustable Ball Mount Work w/ BulletProof Hitches?  

Yes the Demco Lunette Ring part #DM09557-97 will work with the Curt Channel Style Adjustable Ballmount part #C45900. It will be rated for the 1,400 lb tongue weight and the 14,000 lb gross trailer weight rating of the Curt ball mount. Replacement…

Starting with the most significant difference here, the BulletProof Hitches Adjustable 2-Ball Mount #MD204 has a different rise/drop when compared to the Curt #C45900. The #MD204 has a 4" drop and a 4" rise while the #C45900 has a…

The Dexter 2-Tang Clevis #T1807800 has mounting holes that will line up with the BulletProof Hitches 2-Ball Mount for 2-1/2" Hitches #MD254, but the Clevis uses 3/4" pins while the BulletProof shank uses 5/8" pins for the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Great question, Jeff! When the Rota-Flex first came out it renovated what a pin box could do and be, but at this point in time that technology is a little more dated and the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #325-GH-8040 is the…

The first thing you'll need to flat tow your 2015 Chevy Malibu LS is a base plate kit like the Roadmaster part #RM-523178-5 that is a confirmed fit. In addition to the base plates, you will also need a compatible tow bar, safety cables,…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…

I recommend using the Curt Lock Set #C23556 for your Curt Adjustable 2-Ball Mount #C99NR. This comes with a lock for the hitch receiver and one for the ball mount platform. Even though your platform uses 2 pins, only 1 locking pin is needed to secure…