HIghest Quality Trailer Tail Lights & Marker Lights With Grommet

Question

Question:

In need of a best quality, Trailer tail and marker lights With grommets I have not made holes yet to accept lights , Looking for stop,tail ,turn And marker lights Three individual holes will be made on back, Needs to be very eye catching and attractive Suggestions please?

asked by: Stan K

0

Expert Reply:

If you want the highest quality and most eye-catching trailer tail lights, then I highly recommend Optronics LED lights with a plethora of diodes. Let's go ahead and start with the tail lights with stop, tail, and turn functionality. The best lights, as well as the needed grommet and wiring pigtail is the following:

- Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 48 Diodes # STL70RB

- PVC Grommet # A70GB

- 3-Wire Pigtail # A45PB

This is a 6-1/2" long x 2-1/4" tall light, which is among the largest available, and its 48 diodes really pop out nicely to the eye. Then for marker lights, the one I really like is a round, 2-1/2" light that has 9 diodes, which is the most you can get for this size of light; it is also available in either red or amber:

- GloLight LED Trailer Clearance or Side Marker Light - 9 Diodes - Amber # MCL157AB or Red # MCL157RB

- Rubber Grommet # A57GB

- 2-Wire Pigtail # A46PB

expert reply by: Kyle S

0

Answer 1

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 2

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 3

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Answer 8

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 11

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 12

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

HIghest Quality Trailer Tail Lights & Marker Lights With Grommet

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching