How to Measure for Solera RV Slide-Out Awning on 2022 Grand Design Reflection 260RD

Question

Question:

What size slide topper do I need for 2022 grand design reflection 260rd?

asked by: Herbert S

0

Expert Reply:

The slide-out on your 2022 Grand Design Reflection 260RD will need to be measured to determine the correct Solera RV Slide-Out Awning. To ensure you get the correct size for your slide-out, measure from outer edge to outer edge of the trim.

You will need 7" of clearance on both sides of the slide-out for the awning. If you don't have 7" clearance on both sides, go down to the next size; this will still give your slide-out plenty of coverage. The # LCV000182037 you looked at fits slide-outs that are 116" - 121" wide.

I have attached an installation video below, along with a link to all of our slide-out awnings that can be filtered by width for your reference.

expert reply by: Robin H

0

Answer 1

My research indicates that grease seal part 125255UC has an outer diameter of 1.980-inches and this correlates with the hubs that use bearing #L44649. The seal part most often used with inner/outer bearing L44649 is seal part #10-9 which has an inner…

view full answer...

Answer 2

If your rear indicators are not working, it's almost certainly a poor ground, so the first thing to do is take a look at your ground connections to make sure they are attached to bare metal surfaces and free of any paint, dirt or corrosion. What…

view full answer...

Answer 3

A TruRyde rvd-h-865 7k hub/drum like # AKHD-865-7-2-K uses 1/2-inch drive-in studs that are 1-5/16-inches long. For a replacement stud you can use #165981. This is slightly longer at 1-1/2-inches but it has the same 1/2-inch diameter. They are also…

view full answer...

Answer 4

The correct replacement for the Oil Seal 225255UC is the Oil Seal part #9103309. These both have a 2.24/2.25" inner diameter and 3.37" outer diameter. They are also designed for use with oil bath hubs.

view full answer...

Answer 5

Those are good questions. We would first want to confirm the specific model of Ram truck you have. The towing/pin weight capacities can vary between different model. Your owners manual should also specify the towing capacity and pin weight capacity.…

view full answer...

Answer 6

Hey Rose, based on the dimensions and color you mentioned the correct slide topper for your 2024 East to West Alta is the part #LCV000163292.

view full answer...

Answer 7

Lippert Components purchased the Everchill line so we finally have some manufacturer support for the Everchill RV Refrigerator w/ Freezer Drawer #WAY44FR. I've attached the manual below to help you out.

view full answer...

Answer 8

The Solera RV Slide-Out Awning #LCV000251461 that you were already looking at is the correct size for your 115" flange to flange measurement. You would not want to go a size larger as the extension rods that hold the roller tube to the slide-out…

view full answer...

Answer 9

Please note the attached instructions. The Lippert Anti-Billowing Kit for Solera Slide Topper Awnings, #LC78FR should be installed on the end of the awning that is closest to the front of the unit. 1. Make sure awning is fully retracted. 2. Place the…

view full answer...

Answer 10

The Solera 14' Slider (Slide-Topper) in White w/ White Hardware #LCV000163301 comes with everything you need for installation except the #CAM25013 which is an 8 foot length that is shown in the video as you stated. I do recommend getting two of…

view full answer...

Answer 11

You can replace your current Dometic 300 with the Dometic Full-Timer RV Toilet #DOM27FR ( #DOM87FR for white) if you like the elongated bowl design or you can replace it with a Dometic Part-Timer RV Toilet #DOM57FR if you just want another standard…

view full answer...

Answer 12

I checked with MORryde and have attached a dimensional drawing of the 90" x 29" MORryde RV Cargo Sliding Tray item #MR69FR below. I can confirm that measuring from the outside of the bracket's is 28-3/4".

view full answer...