Finding Replacement Camera for Rear of 2014 Itasca Solei

Question

Question:

Im looking for a replace backup camera for a 2014 Itasca Solei 34T.

asked by: Greg W

0

Expert Reply:

I don't know what replacement camera your 2014 Itasca Solei would need as that was before they started putting cameras on them from the factory or pre-wiring them so most likely it was something aftermarket installed. If it is a Voyager setup you would need the part # VGR84VR that you referenced.

If it's Furrion Vision S setup the correct replacement would be the part # FCN48TASF. Furrion has been the most popular camera kit around for a few years now so this would be what I would think it is.

expert reply by: Jameson C

0

Answer 1

According to Buyers Products, their RV Backup Camera w/ Night Vision - Rear Mount, part #3378881211 can be used on any camera systems with 4-pin connectors. Therefore, it will work to replace your camera on the Weldex system in your 2003 Fleetwood…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Since your trailer has the bracket #FRCBRKT-BL that would mean your trailer has the Furrion pre-wiring which is very common for newer RVs. The part #FOS43TASF is a fit for this and would be a really easy install. This gives you a monitor with a 4.3…

view full answer...

Answer 5

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 6

The Furrion camera system we have is a closed system and would not be compatible with the in-dash display so you would need to purchase GM's camera system to be able to connect to your display instead of having another monitor. If you do end up…

view full answer...

Answer 7

To maintain your air pressure in your air helper while you drive you will need the Air Lift WirelessAIR Compressor System #AL74000EZ. This system has a smart manifold which will maintain the air pressure within 3psi while you drive. The Air Lift…

view full answer...

Answer 8

The Voyager RV Side Camera #VCMS12RGPR is the correct replacement for your vcms36rgp that you have. This will replace the passenger side camera with no wiring adapters required. We also have the driver side camera #VCMS12LGPR if you want to replace…

view full answer...

Answer 9

The Replacement Lens for Optronics MCL0028 Series Clearance or Side Marker Light #A0028AB is 3-3/4" wide and 1-13/16" tall. I have included an image with these measurements.

view full answer...

Answer 10

I do have an option but Glo-Brite is no longer in business so you won't be able to get any replacement parts for these lights such as lenses. The only option you have would be a full replacement for which the most similar option we offer is the…

view full answer...

Answer 11

The Sony VCB-MHD1 System including rear camera and front dash monitor has been out of production since around 2010, and repair and replacement parts are no longer available from Sony. Even if you found a used replacement, it would already be overdue…

view full answer...

Answer 12

To flat tow your Jeep Wrangler JK behind your motorhome, you will need a base plate kit, tow bar, safety cables, tail light wiring harness, and a supplemental braking system. Depending on the year of your Wrangler, you may also need a Brake-Lite…

view full answer...