Replacement Wheel Center Cap For a 2013 Jayco 298RLDS With 4.38" Diameter Cap

Question

Question:

Your item - 482EZ Trailer Wheel Center Cap, Chrome, 4.82 Pilot Size My unit 2013 Jayco 298 RLDS Eagle T/T outside diameter of the OEM wheel center caps seem to measure 4.38. that seems to be too small compared to your item noted above. is there another option?

asked by: Al C

0

Expert Reply:

Do understand the Trailer Wheel Center Cap # 482EZ you found is sized too fit a wheel with an opening of 4.82" and the center is smaller allowing it to fit inside the wheel. Our next smallest size center cap is the Americana # AM90077 which is designed to fit a wheel with a 4.25 or 4.27" pilot hole. Be sure to check your wheels pilot hole size to determine the correct fit.

expert reply by: Bud M

0

Answer 1

We do offer several trailer wheel center caps with a black finish. But you will have to check the pilot hole of any cap that you choose. For example,the black cap part #CXF104B has a pilot hole of 4.25" which is a different pilot hole…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

You are correct that is a 3,500 lb axle. If you want a bearing kit the #BK2-100 you looked at is the right one. This comes with a #L44649 outer and #L68149 inner bearing along with a #58846 (10-19) grease seal. If you want a replacement idler hub you…

view full answer...

Answer 7

Hello Dan, I can definitely help with this. It is completely normal for the Curt TriFlex brake Controller #C24VV to show the current gain setting when the brakes are applied, or when the manual override is pressed. It sounds like you have the gain…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

Hey Donald, the best Blue Ox weight distribution would be the pat #BXW0550 as it has a perfect tongue weight range for your 450 lb tongue weight trailer.

view full answer...