Outer Dimensions of Optronics LED Combination Trailer Tail Lights  

I recommend using the Optronics LED Combination Trailer Tail Lights part #TLL160RK to replace both tail lights on your trailer. These are standard rectangular 8" long x 3" wide tail lights common for boat trailers. They are also LED. The…

Most likely your trailer has a 7-way and the reason you referred to it as a 6-way is because you didn't count the center plug. But either way I can help if you have either a 6 or 7-way. Since not all trailer connectors will use what is considered…

The etrailer and Pro Series A frame jacks will use 3/8 inch bolts, which is the standard size for A frame jacks and couplers. For install details and some product demonstration videos, click the provided links.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Tom, all of the lights you mentioned are bright and will easily be visible but the Command #CE44VR is the brightest compared to the part #DG52721PB and #DG52720PB.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

I recommend checking out the Optronics LED Combination Trailer Tail Lights #TLL160RK as they are pretty standard and can replace quite a few versions of a wraparound tail light set. These measure 8-1/16" x 2-7/8" and carry the…

I can tell you were to access the correct brake switch wire to install a brake controller on your 2014 GMC Savana Van. You will need to access the wire behind the BCM (body control module) located behind the dash on the passenger's side of the…

To install the Tekonsha Prodigy P3 Electric Brake Controller #90195 into your 2014 Chevrolet Express the black wire from the controller will go to 12 volt power, the blue wire runs back to your 7-way trailer connector at the rear of your van, the…

The best solution for your Ford F-150 is to get two of the Durabilt Hammerlock Coupling Link for 1/2" Chain #DU96MR. This style of link is a little difficult to install but it's very secure and is designed specifically for the size of chain…

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

The older generations of the Wesbar submersible low-profile lights came with sealed light bulb capsules that are not replaceable. If your capsule is sealed, then your best option is to replace the lights with new lights like part #403026 and #403076.…