Demco Coupler for 2-5/16 inch Ball Flat Mount with 3/4 inch Diameter Bolt Holes

Question

Question:

Can you provide a Demco 2-5/16 coupler number 16759-81 found on Demcos website, flat mount, black for 3/4 hardware?

asked by: Eric A

0

Expert Reply:

We only have the white version of what you mentioned with the part # DM99VR. The # DM69FR has mounting holes that are 5/8 inch.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

The Class II Curt Hitch #C12136 and Class II Draw-Tite Hitch #36493 for your 2016 Subaru Outback Wagon are very similar, but every Class I and Class II and some Class III Curt Hitches require stabilizing straps to be used when towing non trailer…

view full answer...

Answer 5

Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.

view full answer...

Answer 6

I called Cequent, the manufacturer, and have an answer for you regarding the Bulldog Cast Head Coupler with Wedge Latch - 2-5/16 inch Ball - Flat Plate Mount - 20,000 pounds, #BD4420000317. The bolt holes are 5/8 inches. This Coupler can also be…

view full answer...

Answer 7

You would be able to go to the larger tire size of 235/75R17.5 like the part #P35175 to replace what you have and you would have additional weight capacity which could help with the blow outs you are having. You did mention all of the usual suspects…

view full answer...

Answer 8

I don't have the length of the spring bar arms on the Blue Ox 2-Point Weight Distribution System like part #BLU75FR but I can tell you that the frame brackets will need to be installed between 25-27" back on the frame from the center of the…

view full answer...

Answer 9

That is not normal wear for the L-Brackets on your Blue 2-Point #BLU75FR to be that worn. It looks like you have too much angle in the head, so I recommend trying to tilt the L-brackets a little to try and get the bar less on just that one edge, and…

view full answer...

Answer 10

The only differences between the Demco Trailer Coupler #DM14976-52 and #DM88XR are the colors and the mounting bracket design. The part DM14976-52 is silver and has a straight, or no-drop, design with the bottom of the coupler being towards the top…

view full answer...

Answer 11

Yes, for 5,200 standard trailer axles we have the hub part #8-219-4UC3-EZ which is a fit for 5,200 lb axles and has the bolt pattern of 8 on 6-1/2 inches like you said you need.

view full answer...

Demco Coupler for 2-5/16 inch Ball Flat Mount with 3/4 inch Diameter Bolt Holes

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching