Why Won't The Linc Remote For Ground Control 3.0 Leveling System Sync To The System  

While there may be something wrong with the main control panel I recommend verifying the mounting of both the front and rear sensors. If these sensors are not fixed in a position where they will not move or are pointed in the wrong direction that…

We've spoken with Lippert in the past about alternate mounting locations for the rear jacks if there is anything that would interfere with the recommended dimension. Here's what they told us as far as where you can mount the jacks on the…

The Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 is designed for use with fifth wheels and would work extremely well for your 2006 Keystone Raptor. It has six jacks, with two landing gear jacks that mount to existing…

Once the sensor was changed in the Lippert Ground Control 3.0 part #LC675817 then the error code should have cleared itself. I contacted Lippert and they said to make sure the wiring harness from the rear sensor has continuity. If the wiring harness…

I spoke with my contact at Lippert and this is what they sent me about the external sensor issue you have: External sensor error means there is an issue with the rear leveling sensor. This will be located 2-3 foot behind the rearmost axle. There may…

It sounds like you are having an issue with the Zero Point Calibration on your Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System, #LC675817 which is the programmed point that the trailer will return to after each use. And from what you…

The Comm Error code is saying that the communication between controller and touch pad has been lost. I have included a diagram of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817. This will help you check the connections…

In order to sync the Replacement Touchscreen Remote part #LC358601 with the multi-function pad on your 2015 Keystone Cougar 327RES you are going to want to complete the following: 1) To begin syncing the remote to the receiver, both the receiver and…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.