How to Manually Retract Lippert Ground Control Jacks After Replacing Sensor

Question:

I changed the sensor how do I clear the code how do I manually raise back jacks?

asked by: Jeremy

Expert Reply:

Once the sensor was changed in the Lippert Ground Control 3.0 part # LC675817 then the error code should have cleared itself. I contacted Lippert and they said to make sure the wiring harness from the rear sensor has continuity.

If the wiring harness is good and the rear sensor is installed properly, you can try to manually retract the jacks to clear the code. I have attached a snip from the instructions that shows how to manually retract the jacks.

expert reply by: Heather A