Can Curt Weight Distribution C79JR be Used with 2013 Ford F-150

Question

Question:

Will product C79JR fit a 2013 f 150

asked by: Delbert B

0

Expert Reply:

Yes the Curt weight distribution system part # C79JR is compatible with a 2013 Ford F-150. As long as the loaded tongue weight of your trailer is between 800 and 1,000 lb this system will work great for you.

expert reply by: Jameson C

0

Answer 1

Passenger vehicle tires do typically have a have a recommended psi of between 30 and 35 psi, like what you mentioned in your question. Special Trailer tires, however, like the Loadstar ST225/75R15 Radial Trailer Tire w/ White Wheel #AM3S870 that you…

view full answer...

Answer 2

We recommend that all trailer tires be inflated to the max psi stated on the sidewall of the tire. If the tire is under inflated, the weight capacity is lowered to an unknown amount for that tire. Although running lower air pressures can improve the…

view full answer...

Answer 3

I can end this debate for you real fast! Trailer tires, which will have an ST in front of the size, should always be inflated to the maximum psi indicated on the tire. Trailer tires usually do not have a recommended and maximum psi indication so I am…

view full answer...

Answer 4

The weight capacity on the Curt TruTrack 2P Weight Distribution System #C79JR is controlled by the spring bars used and it will not increase by using a heavier duty ball mount. You will have the same tongue weight capacity of 800-1,000lbs and maximum…

view full answer...

Answer 5

So there's an obstruction on your trailer frame that prevents you from installing the chain hanger brackets where they need to be, is that correct? We have the perfect solution for you. The Reese Bolt-On Chain Hangers, part #RP58305 should work…

view full answer...

Answer 6

The reason to install steel plate to enclose an I-beam trailer frame to allow use of a weight distribution hitch's lift brackets is that this method makes for easier replacement of a bracket should one fail. If you directly weld the modified lift…

view full answer...

Answer 7

I have a great solution for using a weight distribution system with your new V-nose cargo trailer. I recommend using the Reese Chain Hangers #RP58305 with the weight distribution system you choose. These brackets can either be bolted onto or welded…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 12

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

view full answer...