Recommendation For Improving Ride Quality While Towing a Trailer With 2022 Ford F-250 Tremor Package

Question

Question:

I have a 22 f250 tremor with heavy haul package. I am towing a 38 ft pull behind I am trying to add the sumo springs to my truck just wasn’t sure which ones I needed because the tremor package puts f350 axles and springs under the truck

asked by: Cory B

0

Expert Reply:

On your 2022 Ford F-250 Tremor for Towing I recommend going with a Equal-i-zer weight distribution hitch. The weight distribution hitch will help you to remove rear end sag by transferring some of the weight to the front axle. It will also help to reduce trailer sway caused by strong winds when driving on highways. When I contacted SumoSprings to confirm fitment on your F-250 they specifically stated they do not currently have any fitments for the Tremor trims.

You will need to select a Equal-i-zer weight distribution based on the tongue weight of your trailer.

600-1,000LBS Tongue Weight # EQ37100ET
800-1,200LBS Tongue Weight # EQ37120ET
1,000-1,400LBS Tongue Weight # EQ37140ET
1,200-1,600LBS Tongue Weight # EQ64FR

expert reply by: Bud M

0

Answer 1

For your Grand Design Reflection 315 RLTS the Equal-i-zer kit part #EQ64FR is going to be the best option as it has the tongue weight range of 1,200-1,600 lbs which will be ideal for most likely where your tongue weight will be when your trailer is…

view full answer...

Answer 2

The best option we can offer to help offset a heavy tongue on a trailer would be a load equalizing device. This device will help transfer the tongue weight of the trailers to the vehicle so you don't have issues such as proposing or vehicle sag…

view full answer...

Answer 3

Since you don't have the 5th wheel half the time, and are concerned about unloaded ride quality, you definitely want the SumoSprings over the Timbren #TFR350SDJ. You also want to make sure the capacity is enough for your pin weight. This means…

view full answer...

Answer 4

For that much tongue weight the best option for a weight distribution system would be the Blue Ox SwayPro part #BXW2003. This has a tongue weight range of 1,500-2,000 lbs and has built in sway control within the head of the system where it holds the…

view full answer...

Answer 5

What you really want to do when choosing a weight distribution system is try to get as choose to the middle of the systems capacity as possible. The typical tongue weight of a trailer will be anywhere from 10% to 15% of the total weight of the…

view full answer...

Answer 6

Thanks for reaching out! Ideally your total tongue weight (loaded trailer tongue plus weight of cargo behind the rear axle of your tow vehicle) will fall in the middle of your weight distribution tongue weight range. Your 12K e4, which is essentially…

view full answer...

Answer 7

You can indeed upgrade to the 2000 lb rated spring bars, part #BXW4014. The Sway Pro systems from the highest to the lowest rated all use the same weight distribution head. To change the weight rating of the system, you'd simply swap out the…

view full answer...

Answer 8

Since you already have a weight distribution system you couldn't also install a second one like the part #RP66022 that you referenced that does have a 12,000 lb total trailer weight capacity. A couple things you should note are that the best way…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Recommendation For Improving Ride Quality While Towing a Trailer With 2022 Ford F-250 Tremor Package

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching