Replacement Foot Pad For Lippert Hydraulic Leveling On a 2018 Forest River Sunseeker 3010DS RV

Question

Question:

I need to replace the landing pad on the leveling system on my 2018 Forest River Sunseeker 3010DS. Can you tell me which ones are the correct ones. They are not welded on they are the bolted kind with a 9 circle.

asked by: Sandra M

1

Helpful Expert Reply:

You will need the Replacement Foot Pad # LC324269 for the Lippert Hydraulic Ground Control Leveling System on your 2018 Forest River Sunseeker 3010DS.

The SnapPad XTRA Jack Pads # SP54FR4 will fit your jacks if you do not already have pads for the jacks. These stay mounted on the jacks so you will not have to crawl under your RV to place and retrieve any pads.

expert reply by: Bud M

1

Serial Number Of Lippert Hydraulic Jack On 2018 Forest River Sunseeker 3010DS
(click to enlarge)

Answer 1

Thanks for the picture! I took a look at what we got for your 2018 Thor Palazzo Motorhome, and it appears you need the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269. This replacement will replace the foot pad…

view full answer...

Answer 2

The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…

view full answer...

Answer 3

You'll have to hold the leg of your jack still so that you can unscrew the bottom of the foot pad to replace it. If you have a large set of channel locks you could do this pretty easily with them. The trick will be hold it tight enough to…

view full answer...

Answer 4

Yes, you'd need to hold the inner jack leg while you remove the bolt from the bottom when replacing the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System part #LC324269. In order to hold the inner jack leg, I…

view full answer...

Answer 5

Yes, the Replacement Foot Pad for Lippert Hydrualic Leveling System #LC324269 will work with your Lippert Level Up system, on your 2018 Coachman SportsCoach 407FW. I have attached a picture of this foot pad being used on a Level Up system.

view full answer...

Answer 6

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz…

view full answer...

Answer 7

If your 2021 Jayco Greyhawk Prestige has hydraulic Lippert Ground Control leveling system then yes the replacement feet part #LC324269 would be correct. I attached a picture of what the jack leg should look like.

view full answer...

Answer 8

I suggest using a strap wrench to hold the cylinder side while tightening the installation hardware on the Replacement Foot Pad, #LC324269.

view full answer...

Answer 9

I went ahead and pulled this Replacement I-Beam Jack Bracket #LC349975 from our warehouse to measure. I have attached the dimensions below. Hope this Helps.

view full answer...

Answer 10

The Replacement Foot Pad #LC324269 that you referenced uses (and includes) a threaded 7/16" bolt for mounting. The mounting hole itself is just about 1/2" in diameter.

view full answer...

Answer 11

Josh, the bolt for the Replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System #LC324269 is 7/16" x 1/2" and needs to be torqued to 132 ft.-lbs.

view full answer...

Answer 12

You are correct, the Replacement Footpad Kit #LC86UD is mounted with the bolt, flat washer, o-ring, footpad and finally the 2nd o-ring before threading into the base of the hydraulic jack.

view full answer...

Replacement Foot Pad For Lippert Hydraulic Leveling On a 2018 Forest River Sunseeker 3010DS RV

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching