Size of Bolt Used for Lippert Replacement Foot Pad # LC324269

Question

Question:

Item # LC324269 what size bolt and size of the hole to mount?

asked by: Edward

0

Expert Reply:

The Replacement Foot Pad # LC324269 that you referenced uses (and includes) a threaded 7/16" bolt for mounting. The mounting hole itself is just about 1/2" in diameter.

expert reply by: Chris R

0

Answer 1

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV…

view full answer...

Answer 2

You'll have to hold the leg of your jack still so that you can unscrew the bottom of the foot pad to replace it. If you have a large set of channel locks you could do this pretty easily with them. The trick will be hold it tight enough to…

view full answer...

Answer 3

The 171317 steps are no longer being manufactured, but we do have a replacement gear plate as part #LC301696, motor part #LC301695, and controller part #LC301702.

view full answer...

Answer 4

The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…

view full answer...

Answer 5

You are correct, the Replacement Footpad Kit #LC86UD is mounted with the bolt, flat washer, o-ring, footpad and finally the 2nd o-ring before threading into the base of the hydraulic jack.

view full answer...

Answer 6

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…

view full answer...

Answer 7

I don't know what type of brackets were used on your 2022 Heartland RV Torque 5th Wheel but we carry the #LC349975, which can really only be installed at one height since they have lip that butts up against the bottom of the I-Beam. If clearance…

view full answer...

Answer 8

The SnapPad XTRA Jack Pads for Lippert Leveling Systems part #SP54FR4 are the exact same as the Replacement Pads for SnapPad Jack Stand Pad System part #SN78FR. The latter part is actually just a replacement for the former which is offered in a few…

view full answer...

Answer 9

Great question. To get the proper Item and fit I will need to know the size and shape of the feet on your system. Are they round, square, rectangle. Do they have a lip or raised edge or are they complete flat and level? The SnapPad XTRA Jack Pads for…

view full answer...

Answer 10

I suggest using a strap wrench to hold the cylinder side while tightening the installation hardware on the Replacement Foot Pad, #LC324269.

view full answer...

Answer 11

Yes, the Replacement Foot Pad for Lippert Hydrualic Leveling System #LC324269 will work with your Lippert Level Up system, on your 2018 Coachman SportsCoach 407FW. I have attached a picture of this foot pad being used on a Level Up system.

view full answer...

Answer 12

I sent your picture to my tech contact at Lippert and they responded with saying that the mounting brackets are designed to go behind and under the cross shaft of the slide out. If you check out the picture I attached you'll see how it would fit…

view full answer...

Size of Bolt Used for Lippert Replacement Foot Pad # LC324269

Product Page this Question was Asked From

Continue Researching