Torklift Superhitch Magnum and Camper Tie Downs that Fit 2020 Ram 3500

Question

Question:

Hi, I am in the market to upgrade my 2017 RAM 3500 SRW to a newer model, probably a 2020 or 2021. Can I move my superhitch magnum and camper tie down setup over to the new truck or do I need some new parts?

asked by: Chris S

0

Expert Reply:

There was a big enough change between the 2017 and 2020 Ram 3500 that a new hitch and tie downs would be required. For the hitch you'd want the part # TLD1111-30 and for the tie downs # TLD2142 and # TLR3510.

expert reply by: Jameson C

0

Answer 1

The TorkLift SuperHitch Magnum Trailer Hitch Receiver - Custom Fit - Class V - 2-1/2" and 2" #TLD1111-30 is a confirmed fit for your 2019 RAM 3500 longbed. It does not require any drilling or raising of the bed but you will be…

view full answer...

Answer 2

Yes, in order to install the TorkLift SuperHitch Magnum Trailer Hitch Receiver #TLD1111-30 on your 2019 Ram 3500 you will need to first remove the factory trailer hitch. On the new Ram trucks this does require a bit of an effort but unlike previous…

view full answer...

Answer 3

Thanks for the picture! To use the TorkLift SuperTruss Hitch Extension 48" Long item #TLE1548 with your 2022 Ram 3500 you are going to want the TorkLift SuperHitch Magnum Trailer Hitch Receiver item #TLD1111-30. This hitch is custom fit…

view full answer...

Answer 4

The correct TorkLift Trailer Hitch Receiver for a 2020 Ram 3500 is the SuperHitch Magnum part #TLD1111-30. The SuperHitch Magnum is the only option available for a 2020 Ram 3500. The TorkLift SuperHitch Original Trailer Hitch Receiver is not an…

view full answer...

Answer 5

If you install the Torklift Superhitch Magnum part #TLD1111-30 on your 2019 Ram 3500 that currently has the rear tie down part #TLD3112 and a factory hitch you would need to replace the tie down with the part #TLR3510 according to Torklift. So yes…

view full answer...

Answer 6

Okay, so there's a lot to get to here, starting with the fact that since you need an extension, you will also need to add a TorkLift hitch and weight distribution system. The reason for that is, standard extenders don't have the capacity…

view full answer...

Answer 7

The only other extension that will meet your 36" requirement is the Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long #RP45018. This extension would have a maximum gross trailer weight of 7,500 lbs/750 lbs of…

view full answer...

Answer 8

Honestly 3,000 lbs of tongue weight is going to be too heavy for a 3500 Ram truck. The hitch you mentioned fits trucks with a narrower chassis and wouldn't be a good fit for the 3500. You'd want to look into another 5500 or 4500 truck.

view full answer...

Answer 9

The Go Power Transfer Switch #342GPTS that you referenced is intended to give you convenient switching between two AC power sources, such as shore AC power at a campground and AC output from a generator. You can use this transfer switch to take your…

view full answer...

Answer 10

Yes. The Go Power Automatic Transfer Switch with Quick Connect Cables - Plastic Case - 30 Amp - 120V #342GPTS will always run off shore power if it is present. Once the shore power is cut off it will switch automatically over to the inverter power.…

view full answer...

Answer 11

There is an internal fuse in the Go Power Transfer Switch part #342GPTS but it is included and you would not need to supply it. Usually 6 gauge wire is used for the wiring from the switch to the charger.

view full answer...

Answer 12

You can manually turn off power from your inverter before switching on your shore power, but most people find this tedious and you'll have a delay in power while you switch over. With an automatic transfer switch like the Go Power #342GPTS all…

view full answer...