Recommended Upgrade for Pop Up Camper with 5.30x12 Tires

Question

Question:

Hello, I have a 2007 J/Trax 1202 popup camper trailer. It needs new tires. It currently has 5-30-12 Hi-Run brand, but I would like something better. What can you recommend? Many Thanks,

asked by: Donna

1

Helpful Expert Reply:

The Kenda K353 Bias Trailer Tire part # AM10066 for load range c or part # AM10068 for load range d is what I recommend for a 5.30x12 trailer tire. These are excellent options backed by a five year warranty. They are rated for 1,045 lbs and 1,250 lbs respectively so make sure you choose the one that matches what you have now. These will be a much better option than the Hi-Run's you have now.

expert reply by: Conner L

1

Answer 1

You do indeed have a 12 inch rim. When you measure the diameter of the wheel, you'll need to measure the diameter of he wheel where the tire bead meets the wheel. I've provided you a cutaway diagram of a wheel showing where the measurement…

view full answer...

Answer 2

Trailer tires should be inflated when they are cold and should be inflated to the max psi rating on the sidewall. In your case you would want to run 80 psi. If you don't inflate them to the max psi figure you will lose weight capacity and…

view full answer...

Answer 3

Bias ply and radial tires are good at doing different things. Bias ply tires have a sturdier sidewall and are thus better for off-road and agricultural applications but still work just fine on pavement. Radial tires track better and run cooler than…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 9

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...