Troubleshooting An A-iPower Inverter Generator That Won't Start

Question

Question:

My sua2300i inverter generator will not start I used a spark checker connected to boot and grounded no power coming from spark plug boot. Its fairly new I had ran it once for about an hour

asked by: Kevin R

0

Expert Reply:

If you're getting no power through the spark plug then it most likely needs to be replaced. Looking at the owner's manual for the SUA2300i it appears that they want you to clean or replace the spark plug every six months or 100hrs of usage.

Just like the # 289-SUA2000i the SUA2300i uses the following spark plug replacements:

AutoLite - 275
Champion - L95YC
NGK - BP4H
Torch - E5T

expert reply by: Kevin C

0

SUA2300i Spark Plug Directions
(click to enlarge)

Answer 1

I went out to the warehouse and measured the Demco Hydraulic Brake Actuator item #DM72VR. The bolt hole spread is 3&quot;. I have linked a diagram below. I have linked a diagram I made below and another one that will show you a few…

view full answer...

Answer 2

Some common issues when trying to start a generator like the A-iPower 2,000-Watt Portable Inverter Generator #289-SUA2000i are: 1. It’s low on oil. This generator requires 10W-30, you&#39;ll want to fill the oil until the upper mark of the…

view full answer...

Answer 3

I would first want to check and be sure you are in fact getting power thru the spark plug on your #289-SUA2000i generator. If you are getting power, but it is not sparking, the spark plug will need to be replaced. The spark plug must be properly…

view full answer...

Answer 4

The A-iPower 2,000-Watt Portable Inverter Generator - 1,600 Running Watts - Gas - Manual Start Item #289-SUA2000i requires 0.38qts of SAE 10W-30 oil.

view full answer...

Answer 5

It looks like the studs in your brake assembly are closer together (center to center) at the bottom. If the center to center bolt spacing matches the photo I&#39;ve provided, then the #23-105-09 you&#39;d looked at would be the…

view full answer...

Answer 6

The Hopkins Never Fade Trailer Bubble Level Set - Graduated - Two Way - Stick On/Screw On #HM08526 you referenced does not come with mounting screws. I recommend using the Hex Screw - Self Drilling Unslotted Washer Head #101131802 for your…

view full answer...

Answer 7

If you have already added the fuse and the trailer charge circuit is not activated in the 2019 Ford F-350 Super Duty with factory integrated brake controller, then you want to make sure the trailer is connected and you press the brake according to…

view full answer...

Answer 8

I attached a diagram that shows how most 7-way rounds like the #PK11720 that you referenced will get wired up. As long as you got yours wired up correctly and your trailer taillights and brakes are functioning correctly that&#39;s all that…

view full answer...

Answer 9

We do have the panels separately. What you&#39;re looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 10

If your A-iPower 2,000-Watt Portable Inverter Generator #289-SUA2000i already has a new spark plug, carburetor, and has fresh fuel in it then the only other thing to check would be the oil. If the pressure is too high or too low it can throw up an…

view full answer...

Answer 11

It sounds to me like the carburetor on your A-iPower 2,000-Watt Portable Inverter Generator #289-SUA2000i is clogged and when you switch the choke from the open position to closed it isn&#39;t able to pull enough gas to keep operating. I…

view full answer...

Answer 12

I reached out to my contact at A-iPower to get his thoughts on why your 2,000 Watt Inverter Generator #289-SUA2000i might be shutting down after 20 or so minutes when trying to power your refrigerator. He did say that the 2,000 watts starting and…

view full answer...