Troubleshooting An A-iPower Generator That Runs For 20 Seconds And Shuts Off

Question

Question:

I change plug got good blue spark ..I can take gas line to carb got good gas..I put a new carb on it hit ran 20 sec shut off no more..help or tell someone to take to I think it 3 year old

asked by: Todd M

0

Expert Reply:

If your A-iPower 2,000-Watt Portable Inverter Generator # 289-SUA2000i already has a new spark plug, carburetor, and has fresh fuel in it then the only other thing to check would be the oil. If the pressure is too high or too low it can throw up an error and shut the engine down. I also recommend pulling the cover off and cleaning out any debris/dust build up in the vents to ensure that it can breathe.

expert reply by: Kevin C

0

Answer 1

The A-iPower 2,000-Watt Portable Inverter Generator part #289-SUA2000i uses a Senci 79CC Engine which is indeed a clone of the Yamaha MZ80. That said, I wouldn't say it is inferior as they are very comparable with the Senci option being much…

view full answer...

Answer 2

The spare tire can be mounted near the wheel and axle to the frame, but you will want more than 5 inches of ground clearance. I recommend the Extra Offset Trailer Spare Tire Carrier by Dutton-Lainson #DL22145 based on your photo. Every extra inch…

view full answer...

Answer 3

If the A-iPower 2,000-Watt Portable Inverter Generator #289-SUA2000i is running but AC power is not available, you have one of the below issues going on. 1. AC Circuit breaker is open. 2. Fault in generator. 3. Poor connection or defective cord set.…

view full answer...

Answer 4

The Voyager WiSight Wireless RV Backup Camera System #ASA37YR you were looking at is only compatible with the RV Backup Camera #ASA74YRor #WVH100 so this would need to be the camera you already have installed or you would need to replace the camera.…

view full answer...

Answer 5

The Ultra Fab spare carrier part #UF15-954730 would work well as a carrier as it was designed to fit 4 inch bumpers like you have and can carry the size wheel tire you mentioned. If your wheel has a 6 bolt pattern you'd want the part #AM32680 or…

view full answer...

Answer 6

Hey Vaughn, thanks for reaching out! The max psi rating of the Americana Aluminum Mod Trailer Wheel #AM22646 will be the equivalent to the rating of the valve stem that you install on it. The Americana Metal, Bolt-In Valve Stem #AM20906 can handle up…

view full answer...

Answer 7

The A-iPower 2,000-Watt Portable Inverter Generator - 1,600 Running Watts - Gas - Manual Start Item #289-SUA2000i requires 0.38qts of SAE 10W-30 oil.

view full answer...

Answer 8

I went out to the warehouse and measured the Demco Hydraulic Brake Actuator item #DM72VR. The bolt hole spread is 3". I have linked a diagram below. I have linked a diagram I made below and another one that will show you a few dimensions.

view full answer...

Answer 9

I contacted the manufacturer, A-iPower, and yes there is a high-altitude kit available directly from them for the A-iPower 2,000-Watt Portable Inverter Generator, #289-SUA2000i. I inquired at what elevation is this needed, they stated they sell very…

view full answer...

Answer 10

The Hopkins Never Fade Trailer Bubble Level Set - Graduated - Two Way - Stick On/Screw On #HM08526 you referenced does not come with mounting screws. I recommend using the Hex Screw - Self Drilling Unslotted Washer Head #101131802 for your fiberglass…

view full answer...

Answer 11

If you have already added the fuse and the trailer charge circuit is not activated in the 2019 Ford F-350 Super Duty with factory integrated brake controller, then you want to make sure the trailer is connected and you press the brake according to a…

view full answer...

Answer 12

I attached a diagram that shows how most 7-way rounds like the #PK11720 that you referenced will get wired up. As long as you got yours wired up correctly and your trailer taillights and brakes are functioning correctly that's all that should…

view full answer...