Fit Of K-Source Universal Towing Mirrors On A 2022 Jeep Cherokee

Question

Question:

Interested in these towing mirrors, do they fit a 2022 Jeep Cherokee? I know they say yes but want to be sure.

asked by: Marcos

0

Expert Reply:

Yes, the K-Source Universal Towing Mirrors # KS3891-2 will fit your 2022 Jeep Cherokee.

These towing mirrors will fit most mirrors 4-1/2" to 11-1/2" tall, have an overall measurement of 4-1/2" to 14" tall x 14-1/2" wide, and mirror face dimensions of 7-3/4" tall x 5-1/8" wide.

I have attached a review video for you to check out as well.

expert reply by: Bryce D

0

Answer 1

Sorry to hear about the K-Source mirrors #KS3891-2 not fitting well to the housing of your 2018 Jeep Grand Cherokee. Due to the tapered size of the outer housing I can see how the straps aren't going to be as secure as you'd like. The best…

view full answer...

Answer 2

With your 2016 Jeep Grand Cherokee The CIPA Custom Towing Mirror #11801 are not confirmed to fit and the manufacturer does not make a slip on version for your vehicle, but The K-Source Universal Towing Mirrors #KS3891-2 will work though. These…

view full answer...

Answer 3

While we don't have any custom fit tow mirrors that fit your 2019 Jeep Cherokee like the CIPA part #CM11401 that you referenced we do have universal tow mirrors like the CIPA part #CM11980-2 which we've test fit on similar Cherokees and found…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink butt…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 12

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...