Towing Mirror Extensions For A 2016 Jeep Grand Cherokee

Question

Question:

Which slip on extensions will fit a 2016 Jeep Grand Cherokee?

asked by: Rebecca D

0

Expert Reply:

With your 2016 Jeep Grand Cherokee The CIPA Custom Towing Mirror # 11801 are not confirmed to fit and the manufacturer does not make a slip on version for your vehicle, but The K-Source Universal Towing Mirrors # KS3891-2 will work though.

These mirrors are extra-large and will mount on your factory side mirrors. The ratcheting system will fit on different shapes and sizes of mirrors. The sliding clip will grab onto the edge of the factory mirror housing and adjust to fit varying mirror thicknesses, its snug fit will reduce mirror vibration.

The mirrors have a black plastic housing that will provide a clean look and will not rust or corrode, and has an easy, tool-free installation and removal with no hardware required.

I attached a review video link below.

expert reply by: Noah E

0

Answer 1

Yes, the K-Source Universal Towing Mirrors #KS3891-2 will fit your 2022 Jeep Cherokee. These towing mirrors will fit most mirrors 4-1/2" to 11-1/2" tall, have an overall measurement of 4-1/2" to 14" tall x 14-1/2" wide, and…

view full answer...

Answer 2

Sorry to hear about the K-Source mirrors #KS3891-2 not fitting well to the housing of your 2018 Jeep Grand Cherokee. Due to the tapered size of the outer housing I can see how the straps aren't going to be as secure as you'd like. The best…

view full answer...

Answer 3

While we don't have any custom fit tow mirrors that fit your 2019 Jeep Cherokee like the CIPA part #CM11401 that you referenced we do have universal tow mirrors like the CIPA part #CM11980-2 which we've test fit on similar Cherokees and found…

view full answer...

Answer 4

While there are no custom fit mirrors for your 2016 Jeep Grand Cherokee, I would recommend the K-Source Universal Dual Lens Towing Mirrors #KS3990, because of the dual mirror adjustment that increases viewing area. I have a video of these installed…

view full answer...

Answer 5

We had the chance to install the universal tow mirrors part #7070-2 on a similar 2014 Jeep Grand Cherokee to your 2016 model and we found that they fit and worked well. Check out the demo video I attached below to see how well they fit and perfor. I…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 8

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...