Is the 4-way flat to 4-way Round # 47465 Compatible with with 4-Pole # PK11404 and # PK11410

Question

Question:

Is the four way round compatible with the Pollak Wiring - PK11404 or the Pollak Wiring - PK11410 vehicle end connector?

asked by: Jonathan

1

Helpful Expert Reply:

I went and pulled the Adapter part # 47465, Pollak Heavy-Duty, 4-Pole, Round Pin Trailer Wiring Socket # PK11404 and Pollak Heavy-Duty, 4-Pole, Round Pin Socket # PK11410 to see if they were all compatible and I found that they were. The round 4-way of the # 47465 is compatible with both the # PK11404 and the # PK11410.

Check out the video I attached where I show this.

expert reply by: Jameson C

1

Answer 1

For a 4-pole round trailer connector and socket, I would recommend looking at the Pollack Heavy-Duty 4-Pole Round Trailer Connector, #PK11409, and the Pollack Heavy-Duty 4-Pole Round Trailer Socket, #PK11410. The connector and socket have a…

view full answer...

Answer 2

I went out to the warehouse and pulled a similar part, #RM-910030, to take some measurements. The only difference is that the part I measured is a flat piece and does not have that lip at the top. The center holes are exactly the same. I took several…

view full answer...

Answer 3

I grabbed a Pollak Heavy-Duty, 4-Pole, Round Pin Trailer Wiring Socket, #PK11404, from our warehouse to measure and found the distance between the mounting holes on center is 1-3/4 inches. If you check out the picture I attached you will see that you…

view full answer...

Answer 4

Most of the time the 4-Way connector is wired as follows. Looking at the front of the socket on the vehicle side with the cover raised the top left pole is the yellow, left turn/brake pole, the top right pole is the right turn/brake pole, the bottom…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 7

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 8

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

view full answer...

Answer 9

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 12

The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.

view full answer...

Is the 4-way flat to 4-way Round # 47465 Compatible with with 4-Pole # PK11404 and # PK11410

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching