What Does 9" Diameter of Replacement Pads for SnapPad Jack Stand Pad System Mean

Question

Question:

These say 9 and 11 inches? Which is correct?

asked by: Cliff

0

Expert Reply:

The Replacement Pads for SnapPad Jack Stand Pad System # SN78FR fit 9" diameter round jack feet and they make that surface area larger to an 11" diameter so both specs are correct. The larger surface area gives your jacks more stability and are pretty simple to install, although you may need some soap, water, and elbow grease to do so.

expert reply by: Jon G

0

Answer 1

The SnapPad XTRA Jack Pads for Lippert Leveling Systems part #SP54FR4 are the exact same as the Replacement Pads for SnapPad Jack Stand Pad System part #SN78FR. The latter part is actually just a replacement for the former which is offered in a few…

view full answer...

Answer 2

The closest compatible option for your Dometic DOTR12CB RV microwave's size is the Furrion Standard RV Microwave #FMSN09BL. It measures 19-1/16" W x 13-5/8" H x 15-7/8" D with a 0.9 cu ft capacity.

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 5

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 6

I am sorry but we do not have an AC cover with those dimensions. The closest option we have is the Replacement RV Air Conditioner Cover for Penguin and Dometic Air Conditioners item #AT3308046006 which measures 40-1/2" long x 29" wide x…

view full answer...

Answer 7

If you have the Gooseneck versions of the Curt CrossWing ( #C92DR or #C32DR) you unfortunately would not be able to use the Rota-Flex with it. The pivoting head causing too much strain for the single point of contact you have with a gooseneck hitch.…

view full answer...

Answer 8

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 9

Yes, you can replace your GE air conditoner with an Advent air conditioner like the Advent Air RV Air Conditioner #ACM150. Additionally, you will also need a thermostat. For that, you can use the Air Distribution Box w/ Built-In Thermostat for Advent…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

The Stromberg Carlson RV Jack Pads for RVs and Trailers - 14" Long x 12" Wide - Rubber - Qty 2, part #SC37VR will fit the jack feet of your 2022 Tiffin Allegro Buss. These pads measure 14" long X 12". Your jack feet should have…

view full answer...

Answer 12

The key here is that the functions are in the correct locations. Wire color is going to vary from manufacturer to manufacturer which is why you should always wire by function and use a circuit tester like #PTW2992 or #PTW 2993 when wiring in a…

view full answer...