How Many Turnbuckles Come with the Replacement Front Turnbuckle for HappiJac Original Turnbuckle Set

Question

Question:

it says set. i hope that means it comes with 2 ?

asked by: Gary S

0

Expert Reply:

The Replacement Front Turnbuckle for HappiJac Original Turnbuckle part # LC182901 is for a single front turnbuckle. If you need a single rear turnbuckle then you'll use the Replacement Rear Turnbuckle for HappiJac Original Turnbuckle part # LC182900 or the HappiJac Original Turnbuckles for Camper Tie-Downs part # LC182898 if you need all four aka a full set.

expert reply by: Conner L

0

Answer 1

The HappiJac Qwik-Load Upgrade Kit for Standard Turnbuckles part #LC182894 is an excellent upgrade option for the HappiJac Original Turnbuckles for Camper Tie-Downs part #LC182898. These are going to cut down dramatically on the time it takes to…

view full answer...

Answer 2

Yes. The TorkLift Basic SpringLoad Turnbuckles for Camper Tie-Downs - Qty 2 #TLS9000 are spring loaded so they'll work well to allow the camper to shift around slightly while not being too rigid on the frame. These do a great job when used with…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.

view full answer...

Answer 6

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

view full answer...

Answer 7

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...

Answer 8

The 07100 bearing number you referenced is an older bearing that has the same dimensions as #L44643. If both the inner and outer bearings on your existing trailer are the 07100/ #L44643, and the hub has a 4 on 4 inch bolt pattern, the correct…

view full answer...