Availability of Lippert Slide Out Motor 236575

Question

Question:

Lippert slide out motor 236575. Is it a 300 or 500:1 motor. Do you stock them?

asked by: Richard W

0

Expert Reply:

We do carry the Lippert Slide Out motor part # LC236575 that you are looking for. This is the 300:1 ratio motor.

expert reply by: Jameson C

0

Answer 1

The only difference between a Lippert slide-out motor with a 300:1 gear ratio and a 500:1 gear ratio, is torque. The 500:1 gear ratio will provide this motor with more torque. As they have the same dimensions and design, you can use the 500:1 gear…

view full answer...

Answer 2

The Replacement Standard Dual Rack Repair Kit for Lippert RV In-Wall Slide-Outs - Fixed Side, #LC84FR is the left side of the slide-out as looking at it, facing it, from the outside. The float side, #LC26VR, will of course be the right side as facing…

view full answer...

Answer 3

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 6

I really wish we had replacement parts still for the Atwood couplers but since they've been out of business for so long we don't have any way to get the parts you are wanting.

view full answer...

Answer 7

The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…

view full answer...

Answer 8

The trailer hitches that fit a 2023 Ford Escape will not fit the Plug-In Hybrid version so we'll need to look into some alternative options so you can carry your extra cargo. If you just need to carry some bikes then I recommend getting the…

view full answer...

Answer 9

The piece you're referring to in the #LC26VR kit is called a "shoe". This part is plastic with foam pads on each end that helps cushion the motor bracket as it slides back and forth to either end of the track.

view full answer...

Answer 10

What you need is a light kit specifically for flat-towing. The Plug-N-Tow TM Vehicle Wiring Harness, #42615, would be if the Jeep were towing a trailer and not for activating its lights while it is being towed. There are a few options for lighting…

view full answer...

Answer 11

Since you have a brand new tow vehicle and a new Tekonsha P3 brake controller I would first focus your troubleshooting efforts on the wiring in the trailer. Something is causing an excessive current draw from the controller. The most common causes…

view full answer...

Answer 12

You link to #C59HR, the Curt Tow Bar Extension Cord w/ Socket. This connects the 7-way, blade-style connector from an RV to the 6-way round connector used for towed vehicles. This drops the black wire, the battery hot lead.

view full answer...

Availability of Lippert Slide Out Motor 236575

Product Page this Question was Asked From

Continue Researching