Replacement Lippert Electric Ground Control Landing Gear Leg for Keystone Cougar

Question

Question:

I need both Lippert landing gear for my 2015 Keystone Cougar 288RLS 5th wheel. They have independent motors. We have the Lippert electric auto leveling system that each motor connects to.

asked by: Pat C

0

Expert Reply:

It sounds like you have the Lippert Ground Control Electric Leveling System and in which case you will need the Replacement Lead Leg for Lippert Components Ground Control 3.0 Electric Leveling System part # LC305340 for the leg and motor or the Replacement Front Jack for Lippert Ground Control 3.0 Leveling System part # LC362485 for just the leg. These will both work on either side of the trailer, front left or front right.

expert reply by: Conner L

0

Answer 1

Thank you for the picture of your jack motor as that makes it very easy to identify it. You are correct the part #LC305340 is the correct jack motor and leg but if you instead wanted just the motor you would want the part #LC343758 and you'd be…

view full answer...

Answer 2

Based on what your VMC900L has wrong with it the best option would be to replace the lead leg with part #LC119102.

view full answer...

Answer 3

In regards to the Lippert Ground Ground Control 3.0 Leveling System, if you just need a new front leg then this can be replaced with the Replacement Front Jack for Lippert Components Ground Control 3.0 Leveling System part #LC362485. If you need a…

view full answer...

Answer 4

There are a couple potential reasons why the back Lippert Power Jack #LC298707 on your trailer won't extend or retract even with the motor running. It's possible that it may have been over-extended or something internally has been stripped or…

view full answer...

Answer 5

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 6

If you're having trouble installing your SnapPads #SP54FR4 then SnapPad actually recommends lifting the jack foot up 3-4" and using a shim to pry the corner of the pad up and help as the jack foot comes back down, sort of like using a shoe…

view full answer...

Answer 7

In order to reset the control panel you will need to manually level the coach and then reset the zero point. If you need help with resetting the zero point you can follow the instructions below. If you were to unplug the control panel or control…

view full answer...

Answer 8

From what it looks like, the Lippert Venture Lead Leg Repair Kit for 5th Wheel RV Landing Gear #LC146059 would work on your landing gear, but without knowing the brand and capacity it's tough to confirm this. If you can find any identifying marks…

view full answer...

Answer 9

For the Lippert Ground Control 3.0 Trailer Leveling System #LC358590 we do offer the front leg only with part #LC362485.

view full answer...

Answer 10

Thanks for the pictures! Based on the part number of your motor it appears you have Venture landing gear. As such you will likely need follow leg rebuild kit #LC146060 or lead leg rebuild kit #LC146059 to fix your landing gear. Landing gear legs are…

view full answer...

Answer 11

If your landing gear leg (inner or outer leg) is bent then I strongly advise replacing it. A bent leg can be an indication of other unseen damage. We have numerous replacement legs available for both the lead leg and the follower leg. But it depends…

view full answer...

Answer 12

In order to find the correct replacement landing gear legs for your 2013 Keystone Laredo 335TG I would need you to take two quick measurements of your existing landing gear legs, the outer tube length and weld stop spacing. I have attached a photo to…

view full answer...