Are Lippert Ground Control 3.0 System Replacement Legs Offered Without Motors

Question

Question:

Lippert Ground Control 3.0 front landing gear PT# 305340. Can I buy just the front jack leg assembly minus the motor 343758 ?

asked by: Scott H

0

Expert Reply:

For the Lippert Ground Control 3.0 Trailer Leveling System # LC358590 we do offer the front leg only with part # LC362485.

expert reply by: Adam R

0

Answer 1

Really you're going to need to measure the distance where the leveling system is going to be installed. If that distance is more than 20', then you're going to want the 6 point Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling…

view full answer...

Answer 2

I don't know what type of brackets were used on your 2022 Heartland RV Torque 5th Wheel but we carry the #LC349975, which can really only be installed at one height since they have lip that butts up against the bottom of the I-Beam. If clearance…

view full answer...

Answer 3

I sent your picture to my tech contact at Lippert and they responded with saying that the mounting brackets are designed to go behind and under the cross shaft of the slide out. If you check out the picture I attached you'll see how it would fit…

view full answer...

Answer 4

Because the gross weight rating on the 2018 Dutchmen Endurance 3556 is greater than 15,500 pounds you will need to use the 6-point Ground Control system #LC675817. The 4-point system is not recommended for this application.

view full answer...

Answer 5

The distance between the insides of the weld stops on the jack leg #LC362485 is 17-1/2 inches and the outer tube diameter is 2-1/2 inch by 2-1/2 inch.

view full answer...

Answer 6

The total weight of the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System #LC675817 that you referenced is 350 lbs.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

For the front legs of a Lippert Ground Control 3.0 kit the replacement front jack leg solution you'd need is the part #LC362485. This will allow you to reuse your current motor and bracket. There isn't a gear replacement kit for the jack…

view full answer...

Answer 9

It sounds like you have the Lippert Ground Control Auto Leveling Landing Gear 3.0 part #LC358590 and are looking for replacement front landing gear legs. For that you would want the part #LC305340 . The part number for the rear would be #LC344792 for…

view full answer...

Answer 10

To manually reset your Lippert Ground Control part #LC358590 you need to hold down the retract and enter buttons at the same time. Try that but if you still get an error code you most likely have a low voltage battery that needs to be charged. Or if…

view full answer...

Answer 11

Sounds like you have a Lippert Ground Control auto leveling system on your 2016 Highland Ridge Open Range like the #LC358590. For a replacement front leg you'd just need #LC362485 and you'd be set. The price for this is at the attached…

view full answer...

Answer 12

Do you get any error code on the controller for the Lippert Ground Control 3.0 #LC675817? Usually that helps to troubleshoot and the manual gives an exact solution for each error code. You might also try resetting the Zero Point Calibration to see if…

view full answer...