Replacement Bearings, Races, Grease Seal and Tang Washer For 7,000LB Axle With Flat Spot on Spindle

Question

Question:

Help what tang washer do I need for 7000 pound axel? This one has a flat spot on top of spindle. Thanks

asked by: Mark E

0

Expert Reply:

The Replacement Spindle Washer # 5-101 is the tang washer that is typically used on spindles that have the flat spot on the threaded end of the spindle.

This washer is included in our Bearing Kit # BK3-210 that fits most 7,000lb trailer axles using Inner Bearing # 25580 and Outer Bearing # 14125A with a 2.125" Grease Seal # GS-2125DL.

We also have the Bearing Kit # BK3-200 that uses the same bearing sizes but a larger 2.250" Grease Seal # GS-2250DL. This kit does not include the tang washer listed above.

expert reply by: Bud M

0

Answer 1

For the #84 E-Z Lube Spindle #TRU87FR, I recommend the Dexter Trailer Idler Hub Assembly #84545UC1-EZ. This hub will include all the bearing races, bearings, lug nuts, grease seal, spindle nut, retaining washer, and dust cap with removable rubber…

view full answer...

Answer 2

You should be fine as long as the rubber of the seal is intact and the metal is not deformed. There is a ridge in the hub that would prevent the seal from getting pressed in so far that the seal would interfere with the bearings. I confirmed this…

view full answer...

Answer 3

We have several styles of spindle washers available. To see them all check out the link I attached to the right. You will need to pick the style that's as close to yours as possible.

view full answer...

Answer 4

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 8

I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for your…

view full answer...

Answer 9

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 10

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 11

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Replacement Bearings, Races, Grease Seal and Tang Washer For 7,000LB Axle With Flat Spot on Spindle

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching