Do You Sell Just a 7-Pin RV-Style Plug from the # PK11-934?

Question

Question:

I am just looking for the plug part of Item # PK11-934. I do not need the 3 extension. Do you have just the plug?

asked by: Brandon S

0

Expert Reply:

While we don't have just the plug from the # PK11-934 individually, the best option is to purchase the # PK11-934 and just disconnect the 3-foot pigtail that comes with it to use the connector.

expert reply by: Bob C

0

Answer 1

If you are referring to the actual wiring then you will want to use Pollak Wiring Harness part #PK11-934. This harness will require you to cut and splice but it would be the only option we have for you as we do not carry OEM parts. However, if you…

view full answer...

Answer 2

The part #PK11-934 is a round 7-way wiring harness that's 3 feet in length for a socket that installs on the vehicle like the part #PK11893.

view full answer...

Answer 3

Yes, the Pollak Wiring Harness Extension #PK11-934 is exactly what you'll need to replace that wiring connection. The round plug on the back is called a US Car Connector and is a universal plug that fits at the back of the vast majority of 7-Way…

view full answer...

Answer 4

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 7

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 8

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 9

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 10

The correct replacement master cylinder kit we have for your Demco setup is the part #DM5918 which comes with the lock out replacement.

view full answer...

Answer 11

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 12

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Do You Sell Just a 7-Pin RV-Style Plug from the # PK11-934?

Product Page this Question was Asked From

Continue Researching