How to Release Trailer Brakes After Trailer Break Away Pin Pulls Out
Question:
how do I get the brakes to release switch will not pull out now these are electric brakes?
asked by: Skip
Expert Reply:
If your break away switch looks like # HM20010 then you should just have to push the pin back in. This will break the circuit and release the trailer brakes. If this does not work then there is some other wiring issue going on. You will need to remove power from the system to get the brakes to release.
You can do this by disconnecting the break away system battery (just remove the power wire from the positive battery terminal). After the brakes release you will want to determine the cause of the malfunction. If the switch is not working properly it will need to be replaced.
You will also want to inspect the wiring and repair any damaged wires, exposed copper strands touching the metal trailer frame, and make sure all grounds are attached to clean and corrosion free bare metal surfaces. I have included a couple of FAQ links on break away systems for you.
Products Referenced in This Question
Hopkins Replacement Break-Away Switch, 7" Lead Wires
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Product Page this Question was Asked From
Replacement Trailer Brake Magnet for 12" Brake Assemblies
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- Brake Magnets
- 12 x 2 Inch
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: SoftStartRV Soft Start for Single Zone Air Conditioner Setup - Qty 1
- Q&A: How to Release the Brakes on a Trailer Once the Break Away Switch Is Activated
- Shop: Hopkins Replacement Break-Away Switch, 7" Lead Wires
- Shop: Timbren Axle-Less Trailer Suspension - Standard Duty - 4" Lift - 5 Bolt Flange - 5,200 lbs
- Search Results: lc211852
- Shop: Lippert Replacement Controller for In-Wall Slide-Out - V-Sync II
- Search Results: air conditioner soft start
- Search Results: soft start
- Search Results: f2021
- Search Results: 751000
- Search Results: 6217
- Search Results: 156~25
- Shop: Roadmaster Direct-Connect Base Plate Kit - Removable Arms
- Shop: Roadmaster Universal Wiring Kit with Smart Diodes for Variable Voltage Incandescent Tail Lights
- Shop: Roadmaster Battery Charge Line Kit for Towed Vehicles
- Shop: Base Plate for Tow Bar
- Shop: Vehicle Tow Bar Wiring
- Shop: Vehicle Tow Bar Brake System
- Shop: Camper Tie-Downs
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Suspension Enhancement
- Article: Testing Trailer Brake Magnets for Proper Function
- Shop: Wheel Well Guards
- Shop: Fender Flares
- Q&A: Disc Brakes for Timbren Axle-Less Suspension
- Q&A: Hub and Drum Compatibility For Timbren Axle-less Suspension 5200-lbs
- Video: EZ Connector Wiring - Trailer Connectors - 319-R7-01 Review
- Q&A: Are Trailer Brakes Always On or Off When Not Connected to a Tow Vehicle
- Q&A: Are Brakes Damaged After Driving 40 Miles With Breakaway Pin Pulled on 2022 NuCamp TaG TT
- Video: Timbren Trailer Axles - Rubber Spring Suspension - TASR5200S03 Review
on Accessories and Parts
