What Do the Fuses That Work with the Curt Fuse Bypass Switch for ATM Mini Fuses Look Like

Question

Question:

My 2013 F150 doesnt have a dome lamp defeat switch. The domes and several other lamps on this circuit stay on when the doors are open. I was thinking of installing this harness and plugging it into the dome lamp circuit of the fuse panel. I would simply remove the current 15 amp low profile mini-fuse, install it into the fuse port in the harness and then be able switch off the dome light circuit easily with the switch included in the harness. Please verify this would work with the low profile mini fuses in the fuse panel. Thank you for your help.

asked by: John J

0

Expert Reply:

The Curt Fuse Bypass Switch for Towed Vehicles part # C93HR works with ATM Mini Fuses which look like the ones in the photo below.

Please note, I can't comment or recommend what you are wanting to do as this is not the intended purpose of the bypass.

expert reply by: Conner L

0

What Do the Fuses That Work with the Curt Fuse Bypass Switch for ATM Mini Fuses Look Like
(click to enlarge)

Answer 1

First, yes you can flat-tow your 2015 Sierra 1500. When flat-towing any vehicle you need 5 items. You need base plates for the towed vehicle, a tow bar, safety cables, lighting for the towed vehicle, and most states now require a supplemental brake…

view full answer...

Answer 2

Yes, the Curt Fuse Bypass Switch #C93HR can be used to make your 2014 Honda CR-V tow ready easier than removing the small 7.5amp ATM fuse. I have attached a video showing the Roadmaster FuseMaster Fuse Bypass #RM76511 being installed on a 2014 CR-V…

view full answer...

Answer 3

For your 2011 Chevy Malibu the 8, 22 and 24 fuse would need to be pulled. Using the Roadmaster #RM76511 and #RM76512 would allow you to easily and quickly bypass all three fuses with just the flick of a switch. These bypasses are compatible with the…

view full answer...

Answer 4

You'll only need a single fuse bypass switch like the Curt Fuse Bypass Switch for Towed Vehicles #C93HR you were looking at. You'll want to pull the ACC Radio fuse, which is fuse #34 and the location can be seen in the attached picture. To…

view full answer...

Answer 5

Most Vehicles and hitches have their own specific hardware to insure proper fit and towing capacity. Our #C13149 hitch includes a hardware kit and installation guide. I attached a video on the installation for your convenience. The hardware specs can…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

What Do the Fuses That Work with the Curt Fuse Bypass Switch for ATM Mini Fuses Look Like

Product Page this Question was Asked From

Continue Researching