Replacement Landing Gear Motor For An Atwood 75721 Landing Gear

Question

Question:

To whom it may concern. I have a 2007 cross terrian toy hauler with a ATwood 75721 landing gear, however, it has stop working, what would you recommend for a replacement. Thank you! Terry

asked by: Terry N

0

Expert Reply:

The correct replacement motor for your Atwood 75721 landing gear, is the Replacement Motor for Stromberg Carlson Electric Landing Gear # LG-142178.

This motor has a maximum weight capacity of 5,500-lbs, and measures 8-1/2" tall, 4" long, and 3-3/8" wide.

expert reply by: Bryce D

0

Answer 1

The Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs item #LG-142178 you were looking at is the correct replacement motor for the discontinued Atwood 75721. The Gearbox for Venture Electric 5th Wheel RV Landing Gear…

view full answer...

Answer 2

The skipping sound you are hearing is the motor drawing too much amperage and then "clicking" loudly as it fails to have enough amperage to move the landing gear. This is very common if the motor needs replacing or the power or…

view full answer...

Answer 3

The Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs #LG-142178 is the correct replacement motor for the discontinued Atwood 75721. The #LC141893 you asked about will also work and is a higher speed motor so it will give…

view full answer...

Answer 4

The price difference does seem backwards, but the faster speed part #LG-141893 has the same weight capacity as the lower speed part #LG-142178 that you also referenced. It's a difference of 5,500 RPM and 7,140 RPM so you would definitely see…

view full answer...

Answer 5

The motor very well might need to be replaced on your 2008 Keystone Everest 5th Wheel Trailer, but there are a few other possible reasons for its slow operation that I recommend checking first. A slow and weak motor can also be caused by low battery…

view full answer...

Answer 6

The replacement motor part #LG-142178 can be used as a replacement for Atwood landing gear. It would be a really simple replacement that would bolt right up. Since you're a mechanic this would be a super simple install compared to what you are…

view full answer...

Answer 7

The Venture M-9000HT is also known as the Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs #LG-142178 and is the direct replacement for the Atwood 75721 Motor. The gearbox assembly is a little different between the two motors…

view full answer...

Answer 8

If the replacing the gear box didn't fix the problem, then as long as the internals of the legs themselves are still in good shape replacing the motor would be the next logical step. Before doing that, I'd use the crank to operate the landing…

view full answer...

Answer 9

We have found that in most all cases that the Lippert Components Tuson High Speed 5th Wheel RV Landing Gear Motor part #LC141893 does work out with the Atwood gearbox. We run into this regularly because of Atwood being discontinued.

view full answer...

Answer 10

You are correct that the proper replacement motor for your Atwood 75721 is the Replacement Motor for Stromberg Carlson Electric Landing Gear, part #LG-142178. You are also correct that the gearbox compatible with this motor is the Replacement…

view full answer...

Answer 11

I was able to locate a wiring guide for jack motor switches such as your Atwood part and from these I linked a diagram for you. I also sent a link to a complete installation guide.

view full answer...

Answer 12

I have a solution for you. First, though, to replace the gearbox for your Atwood 75721, you'll need to replace the motor along with the gearbox since there aren't any gearboxes made for that motor any longer. As you mentioned, due to the age…

view full answer...

Replacement Landing Gear Motor For An Atwood 75721 Landing Gear

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching