Wiring Connector For a Lance Slide In Bed Truck Camper To 2022 Ford F-350 Super Duty  

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

The Swing Out Extension brackets part #LC182496 are designed for HappiJac camper jacks and the 2002 Lance 920 does not have the Happijack system unless you have replaced the jacks at one point. If you have replaced the system with the HappiJacks then…

Yes the Happijac swing out bracket kit part #LC182496 does work with your camper with a set of Happjac truck camper jacks and would also work/be needed for your 2021 Ram truck that is a dually.

As we do not carry the Atwood jacks, I cannot confirm the fitment without knowing the measurements. However, the bolt holes on the HappiJac Swing Out Extension Brackets #LC182496 will measure 7-1/4" between all the bolt holes, picture included.…

The Swing Out Extension Brackets for HappiJac Truck Camper Jacks part #LC182496 is the way to go as the 382819 HD are no longer produced. From what I've gathered they were the same width but had a stronger build for heavier campers. They are no…

You are correct that the difference between using the standard mounting option on the HappiJac Electric Truck Camper Jack System #LC736515-ELKIT and adding the Swing Out Extension Brackets for HappiJac Truck Camper Jack Systems #LC182496 is that the…

The Swing Out Extension Brackets #LC182496 are designed for use with the HappiJac Truck Camper Jack Systems #LC736514-4, #LC736514-ELKIT, #LC736515-4, and #LC736515-ELKIT. If you have one of these kits on your 2006 Lance 951, then you can definitely…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…