Replacement for 84 Inch Bumper on Horse Trailer

Question

Question:

My trailer is 84 inch wide and the holes are 10 inch center to center. It is a 94 Featherlite horse trailer. Do you have one that would work? Thanks

asked by: Dedee M

0

Expert Reply:

All of our bumper strips are 96" long and have the holes pre-drilled out at 11" on center, but the nice thing is these can be cut and re-drilled to accommodate your application. You just need to choose which one has the width you're looking for:

2-1/16" Width - # D2-96
3" Width - # D3-96
4" Width - # D4-96

So these will definitely work, you'll just need to do some modification to make it work.

expert reply by: Jon G

0

Answer 1

We have 3 different rubber bumpers that you can use for your horse trailer. They all measure 96" long but have different widths so you'll just need to choose the appropriate width: 2-1/16" Width - #D2-96 3" Width - #D3-96 4"…

view full answer...

Answer 2

The Pre-Drilled Round Rubber Trailer Bumper #D3-96 weighs 21lbs. It is 96" long, 3" wide and will stand 3" tall.

view full answer...

Answer 3

The holes on your existing bumper seem to be about 11 inches apart. The holes on bumper #D3-96 are also 11 inches apart. You may have to drill a hole or two to get it lined up with the first hole but then it should line up nicely. I have also…

view full answer...

Answer 4

What you'd want to do is drill holes in the Pre-Drilled Round Rubber Trailer Bumper #D3-96 to match the mounting holes of your trailer and you'd be set. The bumper is rubber so it would be easy to drill. The pre drilled holes of this are 11…

view full answer...

Answer 5

The Pre-Drilled Round Rubber Trailer Bumper #D3-96 does not require a steel mounting strip in the inside to install. This bumper has pre-drilled holes and all you need to do is use 9/16" bolts to bolt it onto the rear of your trailer and you are…

view full answer...

Answer 6

You could use some self-tapping screws like #FA1131822 to avoid drilling holes first. If you know about where the wiring is you could position the bumper #D3-96 so as to avoid the wiring. Or another option would be to drill from the backside, if…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hi Kat, The rubber bumpers that we offer are all 96" in length but can come in different widths. Based on the dimensions you provided i your pictures the #D3-96 is going to be the best fit, but you will have to cut it down to size.

view full answer...

Answer 9

The bumper part #D3-96 that you referenced is our best option and could work for you but you will need to make some modifications. You would need to cut it down to the 84 inch length you need and would also need to drill new holes in it that line up…

view full answer...

Replacement for 84 Inch Bumper on Horse Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching