Troubleshooting Air Lift WirelessONE Compressor Randomly Turning On and Remote Not Functioning

Question

Question:

wirelessone kicks on randomly dosenot listen to remote

asked by: Jon B

0

Expert Reply:

I reached out to Air Lift about your Air Lift WirelessONE Compressor System # AL25980EZ and the first thing you should try is unplugging the fuse at the battery for a few minutes in order to reset it. If that does not solve the problem then you will need to unplug the manifold for a few minutes. If neither of these steps fixes the problem then you will need to contact Air Lift directly.

expert reply by: Robin H

0

Answer 1

Replacement Manifold for Air Lift WirelessAIR Compressor System for Air Helper Springs AL26558 is a replacement for the WirelessAIR model compressor systems. Your WirelessONE Gen 1 system is no longer manufactured so the only way to find a…

view full answer...

Answer 2

I reached out to Air Lift about your Air Lift WirelessONE Compressor System for Air Helper Springs #AL25980EZ. They said that more than likely this is a ground issue. Make sure your ground connection is secure on a clean, bare-metal surface. If that…

view full answer...

Answer 3

I can help you with info on greasing the A20 hitch but we don't have a video to share at this time. The zerk fittings for the Curt A20 hitch part #C16140 are located on the front of each jaw.The jaws must be in the closed and locked position for…

view full answer...

Answer 4

The legs of the Curt A20 5th Wheel Trailer Hitch - Dual Jaw - 20,000lbs Item #C16140 have a simple pin and clip to attach to the bed rails. If the clips have been pulled and the pins are too tight to get out I recommend using some WD40 and trying to…

view full answer...

Answer 5

If you are talking about adjusting the height of your 5th wheel hitch like the Curt A20 #C16140 then you will simply need to move the hitch head to the appropriate adjustment holes (see attached picture). Loosen the nuts on the bolts holding the…

view full answer...

Answer 6

Since you mentioned the cotter pins which are used to secure the feet inside the rails, that makes me that you are referring to the connection point between the rail and foot on one of the four corners of the Curt A20 5th Wheel Trailer Hitch part…

view full answer...

Answer 7

The Air Lift WirelessONE Compressor System for Air Helper Springs #AL25980 you have should kick on for a few seconds when you start your vehicle, and may kick on every now and then, but it should not be running constantly. Running constantly would…

view full answer...

Answer 8

For your 2006 Ford F-250 the Air Lift kit you would want is the part #AL57212 since you do not have a fifth wheel or gooseneck hitch. This has been confirmed as a fit for your vehicle and would provide you with additional rear suspension support. The…

view full answer...

Answer 9

Sounds like you may have ran the power wire of the Air Lift Compressor kit part #AL25980EZ to a keyed power source instead of to the vehicle battery so when you turn the vehicle off the compressor loses all power and upon start up resets. The red…

view full answer...

Answer 10

When wiring up the Air Lift WirelessONE Compressor System for Air Helper Springs - Remote and Mobile App #AL25980EZ the power wire needs at least 15 amps to power the unit and the keyed power source that runs to the ignition switch circuit needs at…

view full answer...

Answer 11

You can install a 5th wheel hitch with your AirLift LoadLifter 5000 air bags but the frame brackets on the 5th wheel installation kit part #RP30073 will interfere with the mounting location on the AirLift part #AL57212. Therefore, it is not…

view full answer...

Answer 12

For an air bag kit that is available for your 2006 Ford F-350 4x4 you would want the Air Lift part #AL57212. The #F2398 is not a fit for the 4x4 models and would not work for you.

view full answer...

Troubleshooting Air Lift WirelessONE Compressor Randomly Turning On and Remote Not Functioning

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching