Curt Fifth Wheel C16540 Review Video

As far as height adjustability and weight capacities the Curt Q20 #C16130 and the Curt A20 #C16140 are identical. They both have a Gross Towing Weight of 20,000 lbs, a Vertical Load Limit of 5,000 lbs, and a height range of 13-17 inches. When it…

I recommend going with the Kenda Karrier ST235/80R16 Load Range E #AM10248 over the Transeagle alternative. I know it might sound like I'm being biased because we carry the Karrier, but when I was comparing the tread on the Kenda compared to the…

Yes, the Curt Q20 head part #C16520 can replace the Curt E16 hitch head you have and would work well as a way to upgrade your fifth wheel hitch setup.

Yes, you can replace the head of your E16 Curt fifth wheel hitch with an A16 hitch head part #C16520 and have a much better king pin contact which means much less noise.

There are a couple of ways other than replacing the pin box on your trailer that can help to reduce the chucking you are experiencing. First, I simply recommend checking to make sure the tongue weight of your trailer is around 10-15 percent of its…

I don't know what Curt 20k hitch you have but we do have the Curt A20 part #C84FR that fits your 21 Sierra 3500 and it uses the leg kit part #CU53FR so if you had a Curt A20 you could adapt it to your current truck by just swapping the legs.

The A series of Curt 5th wheel trailer hitches, such as #C16120, is the newest version and is replacing the Q series. The A series jaws overlap whereas the Q series butt up against each other more than overlap. And the bearing and shaft that the head…

Since you mentioned the cotter pins which are used to secure the feet inside the rails, that makes me that you are referring to the connection point between the rail and foot on one of the four corners of the Curt A20 5th Wheel Trailer Hitch part…

If you are talking about adjusting the height of your 5th wheel hitch like the Curt A20 #C16140 then you will simply need to move the hitch head to the appropriate adjustment holes (see attached picture). Loosen the nuts on the bolts holding the…

Yes, a Curt A20 hitch head like part #C16540 will fit the Curt R20 slider part #C16550 that you referenced. The Curt A20 Slider Kit part #C16541 is actually just these two part numbers.

I spoke with Curt and they also confirmed the height of the Adapter Rails for Curt 5th Wheel Hitch #C88KR is 2 1/2" as mentioned on our product page, that is counting with the slightly recessed puck mounts.

I've got the perfect alternative that will save you a few bucks. Take a look at the Curt A20, part #C84FR. The Curt A series features a fully articulating hitch head and a unique split jaw system that grips the king pin very tightly all the way…