Fulton Fold-Away Coupler Hinge For a 3 X 3 Trailer Tongue  

Essentially, you can install a spare tire carrier anywhere it will fit. I recommend placing it on the tongue as far back from the coupler as possible without interfering with anything. This will push its weight as far back as possible on the…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

Yes, a 4.80-12 trailer tire uses a 12 inch diameter wheel that is 4 inches wide. The 4.80 spec is the width of the tire. I have attached a link to all of our 12 inch x 4 inch trailer wheels for you to check out. They come with either a 4 on 4 inch…

The D in 205/75D15 represents that the tire has a bias ply construction whereas the R in 205/75R15 represents that the tire has a radial ply construction. The difference between a bias and radial ply is in regard to the directions of the cords. In…

For your 2021 Chevrolet Silverado you will have to splice into the factory wiring to use the 3rd Brake Light Logic Module #PP20-702 to connect the left and right turn signals, along with the green wire. You can also combine this harness #PP20-702…

It looks like you're on the right track. The #PP20-702 module will separate the brake signal out from the turn signals and the #277-000143 can be plugged into the 7-way in your truck bed and will provide access to the turn signal circuits for the…

If the third brake light is still flashing with the Pacer Performance 3rd Brake Light Logic Module part #PP20-702 installed then the unit is either installed incorrectly or faulty. I have attached a wiring diagram you will need to look over and make…

The Pacer Performance 3rd Brake Light Logic Module #PP20-702 filters out the turn signal and only illuminates the 3rd brake light when the brake pedal is pressed. I have attached a photo of the installation instructions for you to check out.

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hello Dan, I can definitely help with this. It is completely normal for the Curt TriFlex brake Controller #C24VV to show the current gain setting when the brakes are applied, or when the manual override is pressed. It sounds like you have the gain…