Rocker Switch to Mount Outside with Weather

Question

Question:

Single Rocker switch #37212585 I need one of those soft clear plastic weather prof covers that can go over this switch for a exterior application.

asked by: Frank T

0

Expert Reply:

There aren't any kind of clear weather-proof covers that are designed to fit with the Single Rocker Switch # 37212585, but we do have water-resistant rocker switches like part # 37213835 or # 37213815 that would be great alternatives.

expert reply by: Jon G

0

Answer 1

The cut out dimensions listed for the JR Products Switch part #37213815 are right at 3/4 inches wide by 1-1/2 inches tall that we measured when we had one out.

view full answer...

Answer 2

Some harnesses are different and will not match up correctly with the adapter on your vehicle. I would recommend cutting off the head of the 7 way plug on your trailer and installing The 7-Way Molded Trailer Wire Connector #H20042. This harness is a…

view full answer...

Answer 3

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 9

Yes, the TrackTowers part #Y52AV does fit into Yakima HD tracks like what you have installed on your trailer.

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 11

For your setup I recommend the TrackTowers for Yakima Crossbars and Platforms - Track Mount #Y52AV which includes everything you need to mount Yakima crossbars to your Retrax cover (unless you plan on using the Round or HD bars - then you'll need…

view full answer...

Answer 12

Yes, we do. To add a hitch to your 2024 Toyota Grand Highlander, I recommend the Curt Trailer Hitch item #C26VV. This hitch is custom fit and bolts to your Toyota with included hardware. This is a class III hitch with a 2" receiver. It has a…

view full answer...