Replacement Control Module For A Kwikee 26 Series RV Step 909513 Control Module

Question

Question:

Would this part replace the controller unit? 1996 Fleetwood flair. Controller is number 909513 The box makes a mechanical click when switched on, but the motor does not engage. Thanks.

asked by: Aaron

0

Expert Reply:

To replace the control module 909513 on your old Kwikee steps you'll need the Replacement Control Unit for Kwikee Electric RV Steps # LC379606.

Due to the age of your original step my Lippert contact noted that in some cases older steps may not function with this substitute part, but it is the only available option (for just a control module) apart from replacing the entire step assembly.

expert reply by: Kevin C

0

909513 Control Module
(click to enlarge)

Answer 1

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606.

view full answer...

Answer 2

It appears your issue is that you installed the wrong module on your RV steps. Since your module currently says 909513 the correct replacement solution is the part #LC379606 instead. This would explain why your door switch setup is not working…

view full answer...

Answer 3

Since you have a yellow Kwikee module with 909513 on it the correct replacement is the part #LC379606.

view full answer...

Answer 4

We've checked with Lippert before and the correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606 that you referenced.

view full answer...

Answer 5

The Kwikee Control Box 909506000 has been discontinued by the manufacturer. If your steps were manufactured prior to February of 1999 then there are no replacement parts available and you'd need to replace the entire step. If it is between…

view full answer...

Answer 6

Your step control unit PN 909506000 can be replaced with Replacement Control Unit for Kwikee Electric RV Steps - 2 Door Switch Kits #LC379606. You do not need anything else to use this control unit in place of your old one. If your motor and other…

view full answer...

Answer 7

Thank you for the pictures- they're always helpful! I have a solution for you, but the Lippert gear box you were looking at is a replacement for the newer Kwikee 32 Series Steps. I spoke with my contact at Lippert and they said that the gearbox…

view full answer...

Answer 8

I contacted the manufacturer, Lippert, for you in regards to a diagram of wiring the Replacement Control Unit for Kwikee Electric RV Steps #LC379606. I have attached for you below the diagram that they sent me.

view full answer...

Answer 9

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606 which is also correct based on age.

view full answer...

Answer 10

Are you sure that's the number? I can't find any reference to that part number through Kwikee or Lippert.

view full answer...

Answer 11

I looked through a service manual to determine that #LC379608 is correct for your steps but I didn't have to go too far into that manual. This time I had to go pretty far but I finally found that the bolts included with the replacement motor for…

view full answer...

Answer 12

I spoke with my contact at Lippert regarding your Kwikee 32 Series Step Assembly part 90320925. He said that there are a couple of possibilities as to the correct control module part number. If the assembly was manufactured in or before 2005, then…

view full answer...