Kwikee Step Module Replacement 909513

Question

Question:

Upside down and looking up a nine is a six or a six is a nine. The number is 909513 and I believe I need kit 379145.

asked by: Ron R

0

Expert Reply:

Are you sure that's the number? I can't find any reference to that part number through Kwikee or Lippert.

expert reply by: Jameson C

0

Ron R.

6/17/2022

Upside down and looking up a nine is a six or a six is a nine. The number is 909513 and I believe I need kit 379145.

Reply

Jameson C.

6/17/2022

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part # LC379606.

Reply

Answer 1

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606.

view full answer...

Answer 2

The Replacement Control Unit for Kwikee Electric RV Steps - 2 Door Switch Kits #LC379606 is the correct replacement control unit for 909513. It does come with the switches though and there isn't a replacement unit for your model that comes alone…

view full answer...

Answer 3

The correct replacement control module for your Kwikee Steps with Control Module 909513 is the Lippert Components Kwikee Control Unit part #LC379606 which is also correct based on age.

view full answer...

Answer 4

The Lippert Components Kwikee Step Switch Magnet #LC369299 is a normally open circuit setup that completes the circuit when the door magnet is closed. Because of that there isn't a positive or negative designation that you need to worry about.

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 7

It really just depends on what the wires are for. Most likely you have several ground wires among the 8 as well as a couple running light circuits in there as well. You just have to run all of the wires to the correct circuits. The 4-way wiring of…

view full answer...

Answer 8

When installing/adjusting the Solera RV Slide-Out Awning #LCV000163285 tension is applied by rotating the awning roller 14 times. This should apply the needed spring tension so that the fabric doesn't billow in the wind or leave enough slack that…

view full answer...

Answer 9

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 10

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Kwikee Step Module Replacement 909513

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching