What is the Diameter of the 9-Tooth Gear of the Replacement Motor for Kwikee Revolution # LC380073?

Question

Question:

Exact diameter of 9 tooth gear ? Thanks

asked by: Bruce

1

Helpful Expert Reply:

The exact diameter of the little 9-toothed gear on the Replacement Motor for Kwikee Revolution Series Electric RV Steps # LC380073 is 15/16 of an inch. I went ahead and included a diagram of the dimension for your convenience.

expert reply by: Bob C

1

Replacement Motor for Kwikee Revolution Series Electric RV Steps # LC380073 Gear Diameter
(click to enlarge)

Answer 1

Yes, the 28 series and 32 series Kwikee Steps #LC3722617 both use the same wiring harness connectors.

view full answer...

Answer 2

The Kwikee 32 Series Double Step part #LC3722617 that you referenced is a replacement for the Coach step you have now. You will have to cut that wire that runs to the old module and splice it to the new module.

view full answer...

Answer 3

Yes, the Lippert Kwikee 32 Series Electric Step part #LC372261 comes with the motor, linkage, control board, switch and everything else you need to use them. The mounting plate is 25-1/4" wide x 11-3/8" deep which you will need to make note…

view full answer...

Answer 4

If you want to replace the entire assembly what you are going to need is the Lippert Kwikee 32 Series Electric Step #LC372261 which includes the motor, control unit, and switch kit. These steps will fit mounting brackets that are 25-1/4" wide x…

view full answer...

Answer 5

To determine the correct replacement landing gear for your 5th wheel trailer, you will need to measure the mounting brackets on your trailer from the underside of the top bracket to the top of the lower bracket as shown in the diagram. From there you…

view full answer...

Answer 6

We can help you determine the correct replacement landing gear for your Monta Vista, though landing gear is a universal type of fit, and there isn't specific landing gear that fits your trailer. So in order to determine the correct replacement…

view full answer...

Answer 7

For your Venture landing gear set the correct follower leg you'd need is the part #LG-179014 which matches what you sent in a picture of.

view full answer...

Answer 8

You will either need to connect to your truck or have another stabilizer to support the weight when you remove the landing gear. The lead or follow leg can then be removed by loosening the welded brackets that hold the leg in place and move them…

view full answer...

Answer 9

According to my contact at Stromberg Carlson, their #LG-179014 follower leg would indeed be an acceptable replacement for your Venture #900-40L if the 29-1/2 inch outer tube and overall heights of 33-1/2 match your existing jack. You can see these…

view full answer...

Answer 10

I was not able to reference the part number "VMI900L" but in order to determine if the Replacement Follow Jack w/ Drop Leg part #LG-179014 is the correct replacement for you, you will need to measure the distance between the bracket stops…

view full answer...

Answer 11

Sounds like the correct follower leg you would need is the #LG-179014 that you referenced. The overall length of the leg is 33-1/2 inches and the distance from the inside of the two brackets is 17-1/2 inches. Check out the picture I attached for more…

view full answer...

Answer 12

Based on your picture the replacement motor you need is actually the part #LC380073. This would explain why the #LC379608 that you referenced is not fitting at all.

view full answer...

What is the Diameter of the 9-Tooth Gear of the Replacement Motor for Kwikee Revolution # LC380073?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching