Follow Leg Recommendation for Venture Landing Gear on Fifth Wheel Trailer

Question

Question:

I need follow leg... Do you have it? VMC940RB

asked by: Blake J

0

Expert Reply:

For your Venture landing gear set the correct follower leg you'd need is the part # LG-179014 which matches what you sent in a picture of.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Sounds like the correct follower leg you would need is the #LG-179014 that you referenced. The overall length of the leg is 33-1/2 inches and the distance from the inside of the two brackets is 17-1/2 inches. Check out the picture I attached for more…

view full answer...

Answer 2

The correct replacement follower leg for your set that has model number VMC900L is the part #LG-177201. If your other leg is still working fine there would be no reason to replace it at this time.

view full answer...

Answer 3

The only follow leg I can recommend you use with your Venture landing gear would be the part #LC179014. Stromberg Carlson makes the Venture landing gear, that is the brands are different but the jacks are the same. I cannot recommend you install a…

view full answer...

Answer 4

Based on your picture the replacement motor you need is actually the part #LC380073. This would explain why the #LC379608 that you referenced is not fitting at all.

view full answer...

Answer 5

According to my contact at Stromberg Carlson, their #LG-179014 follower leg would indeed be an acceptable replacement for your Venture #900-40L if the 29-1/2 inch outer tube and overall heights of 33-1/2 match your existing jack. You can see these…

view full answer...

Answer 6

You will either need to connect to your truck or have another stabilizer to support the weight when you remove the landing gear. The lead or follow leg can then be removed by loosening the welded brackets that hold the leg in place and move them…

view full answer...

Answer 7

I was not able to reference the part number "VMI900L" but in order to determine if the Replacement Follow Jack w/ Drop Leg part #LG-179014 is the correct replacement for you, you will need to measure the distance between the bracket stops…

view full answer...

Answer 8

To determine the correct replacement landing gear for your 5th wheel trailer, you will need to measure the mounting brackets on your trailer from the underside of the top bracket to the top of the lower bracket as shown in the diagram. From there you…

view full answer...

Answer 9

It sounds like you may have a power issue getting to the Steps #LC3725791 on your 2021 Winnebago Forza 36H RV Motorhome. On the steps you will have a 12 gauge red wire which runs to a 12 volt power source. There is also a 16 gauge yellow wire which…

view full answer...

Answer 10

When replacing the Motor #LC380073 on your Kwikee Revolution Steps #LC3725791 you need to use a jack or another object to hold the steps in the retracted position.

view full answer...

Answer 11

From what you describe I suggest you examine the motor and gears as it appears they are worn. The Replacement Motor for Kwikee Revolution Series Electric RV Steps, #LC380073 is the correct part number. Or, for a complete replacement of Kwikee…

view full answer...

Answer 12

It sounds like you are experiencing chattering on your Kwikee Revolution double step. I reached out to my contact at Lippert who said that when the steps start acting like that the motor does need to be replaced. According to the 901 number you gave…

view full answer...

Follow Leg Recommendation for Venture Landing Gear on Fifth Wheel Trailer

Product Page this Question was Asked From

Continue Researching