Does Malone Hanger Trunk Bike Rack Fit 2020 Kia Soul

Question

Question:

I just saw a recent response back about not having a compatible bike rack for a 2020 Kia Soul - but it does show on your site that this rack does fit and is confirmed for a 2020 Kia Soul - I did contact Malone directly and they too said it does fit. Wondering if that response was given before you had this particular bike rack available - really need to make sure that this rack will fit the 2020 Kia Soul. What is the return policy on the bike racks?

asked by: Anne S

0

Expert Reply:

Sorry for any confusion but we have verified that the Malone Hanger Trunk Rack part # MPG2139 does fit your 2020 Kia Soul. This matches with what they told you as well so it does for sure fit.

I believe I found the older info you mentioned that said there were no fits for your vehicle and sent an update to have it addressed.

expert reply by: Jameson C

0

Answer 1

As long as there is a gap at the top of your rear spoiler for the mounting strap to pass through and attach to the edge of the rear hatch (rather than the straps passing up and over the spoiler), the Thule Passage 3 bike rack #TH911XT will install…

view full answer...

Answer 2

I have a solution for you, but there are no 4 bike trunk racks on the market, mostly because they're just not able to hold the additional weight safely. With that said, you can use something like the Yakima FullBack 3 #Y02633 which will carry…

view full answer...

Answer 3

The only trunk mount bike rack available for a 2020 Kia Soul EV due to the design of the hatch is the Hollywood Racks Over-the-Top 2 Bike Carrier part #HRF2 which is an excellent option with anti-sway cradles to keep the bikes in place, foam pads to…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 7

The Kuat Sherpa 2.0 #SH22G and the NV 2.0 #NV22G that you referenced are both excellent platform-style racks that will hold your bikes by the front wheels with no frame contact. These are top-of-the-line carriers and you really would not go wrong…

view full answer...

Answer 8

To determine if your motorhome has the Tiffin air brake setup or Freightliner BrakeSync you'll need to look at the rear and see if there's an quick disconnect fitting for your air line. The standard Tiffin air coupler fitting would look like…

view full answer...

Answer 9

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 10

I do have an option for you but most factory motorhome trailer hitches have a maximum capacity of 5,000 lbs. If you have a larger vehicle that you need to tow, this will have to be replaced. I don't have a bolt-on option for you but still an…

view full answer...

Answer 11

For your 2024 Toyota Sienna XSE I recommend the etrailer Trailer Hitch Receiver #e56RR. This features a 2" receiver with a bolt-on installation. It has a 350 lb max tongue weight which should be more than enough for your bike rack and bikes. It…

view full answer...