Can Brake Controller Install on 2021 Ford F-150 without Tow Package

Question

Question:

I didn’t get the tow package with truck Ford motor Corp said I’ll never be able to get brake control and 7 pin wiring or computer turned on to reconize 12 volt power needed for trailer brakes

asked by: Bert A

0

Expert Reply:

To install a brake controller on your 2021 Ford F-150 that does not have the factory tow package all you need is the 4-way kit part # C75WR, the # ETBC7 to covert it to a 7-way and wire in the brake controller and then a controller like the Brake EVN # TK63VR.

expert reply by: Jameson C

0

Answer 1

The Curt Echo Under-Dash Trailer Brake Controller part #C27JR as with most any electric trailer brake controller will draw a very small amount of power even when the vehicle is off so it can save all your settings. That said, the power draw is…

view full answer...

Answer 2

I recommend the Tekonsha Prodigy P3 Trailer Brake Controller for your 2022 Ford F-150. This brake controller is proportional so once you have it adjusted to your trailer it will automatically adjust braking output for light and severe braking…

view full answer...

Answer 3

The brake controller port on a 2021 Ford F-150 (if equipped) will be located behind the coin tray in the center console. This will be accessed by removing the panel under the steering wheel. I have attached a video which shows this below. For a brake…

view full answer...

Answer 4

You can install a 7 way connector on your 2019 Ford F-150 by using the Curt T-Connector #C56413, which will plug into the factory supplied 4 way connector plug on your vehicle and give you a fully functioning 7 way connector. If you've got a…

view full answer...

Answer 5

For a complete flat towing setup you need 5 primary items, a base plate kit, tow bar, safety cables, vehicle wiring to link your towed vehicles indicator lights with your motorhome, and a supplemental braking system. Sometimes additional items may be…

view full answer...

Answer 6

Wireless brake controllers like the Curt Echo Mobile #C51180 draw power through the 12 volt accessory circuit wire of the trailer wiring that connects to the positive post of the vehicle battery. The taillight circuits are not used for that at all.…

view full answer...

Answer 7

It is possible to install an auxiliary transmission cooler on a 2020 Ford F-150 with 10R80 Transmission. That said, the factory transmission cooler isn't where it normally would be, in front of the radiator. It's under the actual transmission…

view full answer...

Answer 8

We haven't had a chance to install a brake controller in a 2023 Ford F-150 yet (3/27/2023), so I can't tell you the wire color but I can tell you how to figure out which one you need to hook to. You'll need to use a circuit tester like…

view full answer...

Answer 9

Normally you can find the brake light switch under the dashboard at the top of the brake pedal. There could be a number of wires attached to the switch so you can use a tester like part #PTW2993 to test the wires. Since the auto manufacturers can use…

view full answer...

Answer 10

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at the…

view full answer...

Answer 11

To connect your vehicle that has a 4-Way flat connector to your trailer that has a 7-Way connector, you will need to install a 7-Way on the rear of your vehicle. If you just want or need the tail light functions to operate on your trailer you will…

view full answer...

Answer 12

The best transmission cooler for your 2019 Ford F-150 with a 2.7L V6 EcoBoost engine or 3.5L V6 EcoBoost engine is the Derale Series 8000 Transmission Cooler #D13503 because it is the most efficient cooler available for your F-150. The Derale #D13503…

view full answer...