Will Timbren part# TGMRCK25S fit on a 2007 Chevy Silverado Classic 3500

Question

Question:

Ity doesnt specify if it will fit a 3500 Classic Chevy. Is there a difference between the 2500 and the 3500?

asked by: Jeff K

0

Expert Reply:

The difference between the 2007 Chevy Silverado 2500 and the 3500 series trucks is the weight capacity. The 3500 is going to have a higher weight capacity than the 2500.

I spoke with the engineer at Timbren and he told me that the TImbren part # TGMRCK25S will fit on your 2007 Chevy Silverado Classic 3500, because the Timbren springs for the 2500 and 3500 models will install the same way on both truck models. These springs were tested up to 6,000 pounds and work well within those guidelines. Keep in mind that these springs do not increase the weight carrying capacity of your truck. You should not exceed the weight capacity specified by your Chevrolet Truck owners manual.

For the comparable Timbren springs for the 3500 model is part# TGMRCK35S. These springs were tested up to 8,600 pounds. Again, keep in mind, these do not increase the weight carrying capacity of your truck.

I have attached a Timbren Suspension Enhancement Systems article that may assist you when installing your system.

expert reply by: Lori W

0

Answer 1

Timbrens really are a great solution for suspension enhancement as they do not require you to maintain air pressure or run any air lines. The Timbren kit you'd need is the part #TGMRCK35 which is confirmed as a fit for your 1990 Chevy…

view full answer...

Answer 2

The Detail K2 Snowplow #K2AVAL8219 will fir your 2020 GMC Sierra 1500 even with the big 35" tires and lift. The potential issue is functionality. A plow attaches to your frame, which is now separated from your suspension by another 4 inches…

view full answer...

Answer 3

Thank you for the photo; and while it is very likely, I don't have the exact dimensions of the Leer Hi/Lo camper shell on your 2004 Chevy Silverado with an 8 foot bed in order to say with certainty if you can use the Rhino-Rack roof rack…

view full answer...

Answer 4

The Timbren suspension kit part #TGMRCK35 that you referenced fits your 1995 GMC K3500 without drilling so it would be a great solution for you. It also would not interfere with an aftermarket sway bar either so it would work well in that regard…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...