Corrosion Resistant Version of Wheel Stud # 7-122

Question

Question:

Do you offer this stud in a plated version for boar trailers?

asked by: Jim D

0

Expert Reply:

We have the part # 7-150 which is just a tiny bit longer by 3/32 of an inch but aside from that matches the # 7-122 but is galvanized.

expert reply by: Jameson C

0

Answer 1

I checked with Dexter and was able to verify the correct studs for the Dexter Trailer Hub and Drum 42656. Per Dexter the correct replacement is the 2" long stud, which is the following part number: - Trailer Hub Wheel Stud - Drive In -…

view full answer...

Answer 2

I would be happy to help you find the correct replacement wheel studs for your hubs, but unfortunately the part number shown in your picture are for the brake assemblies and not the hub. To determine the correct replacement wheel studs you will…

view full answer...

Answer 3

I was not able to track down specific information regarding the studs for your existing hubs, but if you have a 5,200 to 6,000 pound hub with the 6 on 5-1/2 inch bolt pattern you mentioned, you will likely need a 1/2 inch drive-in stud. If your…

view full answer...

Answer 4

The Trailer Hub Wheel Stud part #7-122 which measures 1/2" diameter x 2" long with a .62" spline length would be the best match option we have for you.

view full answer...

Answer 5

According to my Dexter Axle representative, the correct drive-in 1/2 inch wheel stud for your #8-213-5UC1-EZ idler hub is part #7-122.

view full answer...

Answer 6

You should be able to replace the wheel stud, but you'll need to drive the stripped stud out and get the measurements shown in the provided diagram in order to locate the correct replacement. You'll need a drift punch that is smaller in…

view full answer...

Answer 7

Thanks for the photo. Honestly 5 inches of clearance from the fender to the top of the tire is fine if that is what you desire. We normally recommend 4 inches to allow for the suspension travel whether with leaf springs or torsion axles to allow…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 10

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 11

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 12

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Corrosion Resistant Version of Wheel Stud # 7-122

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching