What Does the Tekonsha 118243 Fit?

Question

Question:

look in the end of the square connector and see if it has 8 pins. 4 large and 4 small. send pic if possible.

asked by: TCs G

0

Expert Reply:

The plug on the end of the Tekonsha # 118243 that connects to the vehicle does indeed have 4 larger pins and 4 smaller pins. I included a picture of the plug end of the harness, but it isn't super easy to see the pins.

It should be noted that this will fit a 1999 to 2001 Ford F-250 and F-350, F-350, F-450, and F-550 Cab and Chassis, and the F-53 with the factory tow package.

expert reply by: Lazer S

0

Tekonsha 118243 Plug
(click to enlarge)

Answer 1

Since you're needing everything from the rectangular connector back, we have exactly what you're looking for. You'll need the Tow Ready #118243. Once you unplug the existing gray plug, this connector assembly will take its place. I've…

view full answer...

Answer 2

I would start by inspecting the connector on your trailer and the vehicle to make sure there is not corrosion in the connector which could be causing a bad or weak connection. If there is corrosion in the trailer side connector, you would need to…

view full answer...

Answer 3

I am not entirely sure what process you took so I'll give you some other things to try, or maybe a different way to test the Prodigy P3 #90195. First, sever the blue wire a couple inches from the back of your controller. Then use a circuit tester…

view full answer...

Answer 4

There are several items you might want to try using for removal of corrosion in your 7-way trailer connector, like part #HM48480. White Vinegar A wedge shaped, slip on pencil eraser or art gum eraser Pipe cleaners PB Blaster If the corrosion is…

view full answer...

Answer 5

It sounds like your truck will use a 7-way harness like Hopkins #40167 which uses connectors like what you describe. Please refer to the linked photo that shows those connectors. This includes a 7-way socket that plugs into the included round U.S.…

view full answer...

Answer 6

The High Pointe RV Convection Microwave #HP49ZR has a rated input power on convection of 1,500 watts.

view full answer...

Answer 7

The Dexter part number 023-357-00 is a 12x2 electric brake assembly. The correct RH assembly to use to replace what you have would be the part #23-459 and for the LH assembly you would want the part #23-458 if you have 6K axles. If you have 7k axles…

view full answer...

Answer 8

The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…

view full answer...

Answer 9

The High Pointe RV Convection Microwave #HP49ZR you found is only designed for mounting inside a cabinet space. To mount a microwave below the cabinet you will need to use an over the range style microwave like the High Pointe #HP94ZR. This microwave…

view full answer...

Answer 10

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires: Orange = 12 Volt Power White = Ground Black/Green = Reverse Blue =…

view full answer...

Answer 11

While we do not have the technical drawings of the Firestone Heavy Duty Air Compressor #F9499 I can tell you the dimensions. This unit measures 8" long, 3.94" wide, is 6.3" tall, and has a maximum PSI of 150 PSI. Additionally, this…

view full answer...

What Does the Tekonsha 118243 Fit?

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching