Dimensions of Roadmaster Dual Hitch Receiver Adapter 10" Rise/Drop

Question

Question:

Hello. I looking at the RM-077-10 to hold my Thule T2 bike rack while flat towing my 2019 Jeep Wrangler Unlimited with a Blue Ox Alpha One towbar. My goal is to get the bike rack as high and as close to the RV as possible. It do this, I would like to clear my rear bumper with the shank of my bike rack. This means that that distance from the center pin of my hitch to the top of my bumper is a rise of 8 5/8inch Additionally, the horizontal distance from the RV hitch pin to the rear bumper is 6 1/8. I see that the -10 has a triangular support plate. What is the measurement from the pin hole to the support? What is the measurement receiver pin hole to the pin hole?Thanks!!

asked by: Robert

0

Expert Reply:

I have attached for you below a photo with the requested measurements of the Roadmaster Dual Hitch Receiver Adapter 10" Rise/Drop part # RM-077-10.

expert reply by: Conner L

0

Roadmaster 10" Dual Hitch Dimensions
(click to enlarge)

Answer 1

I couldn't recommend the use of the #RM-077-8 with your 12 inch extender as that would be way too long, but it's possible that this by itself would work for you. You'd end up with an extension of 10-3/4 inches instead of the 12 you have…

view full answer...

Answer 2

The distance from the center of the hitch pin that will go into your RV hitch to the back of the receiver tube is right at 7-1/4 inches. I attached a review video for this product for you to check out as well.

view full answer...

Answer 3

I recommend the Roadmaster Dual Hitch Receiver Adapter, 10" Drop/Rise item #RM-077-10. This adapter was designed for this type of set up. Your Jeep Rubicon and Swagman E bike rack weigh well below the 10,000 lbs maximum capacity of this hitch. I…

view full answer...

Answer 4

The Roadmaster Dual Hitch Receiver Adapters like part #RM-077-4 can be used for both a bike rack and cargo carrier and you can also use them inverted (rise/drop position). The Roadmaster Dual Hitch Receiver Adapters are also offered in a few other…

view full answer...

Answer 5

The Roadmaster Dual Hitch Receiver Adapter #RM-077-8 that you referenced is designed for exactly your situation. It will allow your tow bar to set level as you flat tow the lifted vehicle.

view full answer...

Answer 6

In regards to the Blue Ox High-Low Adapter for Tow Bars part #BX88132, the distance from the center of the hitch pin to the back of the upright is 7-3/4".

view full answer...

Answer 7

I measured the Roadmaster Dual Hitch Receiver Adapter #RM-077-8 for you. On the long support arm the distance from the back of it to the center of the hitch pin hole is 6-5/8 inches. But to the support gusset that measurement is 4-3/4 inches. I have…

view full answer...

Answer 8

What you're needing is called an anti-rattle device. My most often recommended solution is the #63232 which is lockable and works very well for ball mounts or hitch accessories with hollow shanks. If your hitch accessory shank isn't hollow,…

view full answer...

Answer 9

Yes, the Roadmaster Dual Hitch Receiver Adapter, 8" Drop/Rise #RM-077-8 that you referenced is actually designed specifically for your situation to allow a tow bar to sit as level as possible. I attached a review video for this for you to check…

view full answer...

Answer 10

We do have Malone adapter #MPG544 which measures 9 inches from the center of the hitch pin hole to the back of the top receiver. If you are needing the dual receiver in order to carry an accessory at the back of your RV while also towing a vehicle…

view full answer...

Answer 11

I have another option for you, but you cannot safely use the Roadmaster Anti-Rattle Hitch Extender #RM-071-1075 and Dual Hitch Adapter #RM-077-10 you mentioned together as they will cause a not very secure connection and will render your trailer…

view full answer...

Answer 12

Yes, you can use a dual hitch adapter for flat towing and carrying a bike rack at the same time. You just need the one with the correct rise or drop, and you can choose from the following: - 2" or 4" Drop/Rise: Roadmaster Dual Hitch…

view full answer...

Dimensions of Roadmaster Dual Hitch Receiver Adapter 10" Rise/Drop

Product Page this Question was Asked From

Continue Researching